1/235
Looks like no tags are added yet.
____ and ____ indicate a mandatory requirement
Shall and Will
______ indicates a preferred, but not mandatory method of accomplishment.
Should
____indicates an acceptable or suggested means of accomplishment.
May
A WARNING is a:
Operating procedures, techniques, etc. that may result in personal injury or loss of life if not carefully followed.
A CAUTION is a:
Operating procedures/techniques that may result in damage to equipment if not carefully followed.
A NOTE is a:
Operating procedures/techniques that are essential to emphasize.
There are __ oxygen supply regulators on the flight deck and ___ oxygen supply regulators in the cargo compartment.
6 (flight deck); 4 (cargo compartment)
Mounting provisions are provided for the installation of ___ emergency first aid kids, ___ in the flight station and ___ in the cargo compartment.
22; 2; 20
During a gear-up landing, open and secure:
overhead escape hatches, side exits, and paratroop doors.
During the EXTERIOR INSPECTION checklist, enter the nose wheel area from the ____ side only. Do not enter from the ____ side of nose wheel due to the possible hazard of venting liquid oxygen.
left; right
When OXYGEN QUANTITY (LOX) drops below ____, the digital readout will turn to red.
2.5 liters
To ensure cross-ship manifold priming is successful, the _____ indicator shall be observed/monitored during the priming procedure.
FUEL PRESS
When the airplane is parked with the fuel tanks more than 3/4 full (6400 pounds in the outboard and 6000 pounds in the inboard), all crossfeed valves should be ______
Closed
The fuel quantity totalizer ______ any error caused by a degraded or failed fuel quantity indicator.
reflects
Cold weather is generally considered to be?
0 degrees C / 32 degrees F and below
When operating the APU with less than ____ pounds of fuel in the No. 2 tank, place the No. 2 ENGINE START switch to RUN to maintain surge box fuel level.
2000
Before the application of de-icing fluid, ______
Shut down the APU and close all doors and hatches
Oxygen system: Under a continuous breathing condition, the pressure should indicate:
270-340psi
Hot weather operating is operation in temperatures above:
35 degrees C / 95 degrees F
Entry and exit through the paratroop doors with engines running is prohibited in which condition:
engines in Hotel mode and flaps extended
Protection against asymmetrical operation of the flaps is provided only during ____
normal hydraulic flap operation
Bailout from the crew entrance door is not recommended at air speeds above _____ KIAS or with the gear extended.
150
During ditching, when should personnel inflate life vests?
after exiting and clear of the escape hatch
Life raft emergency release handles must be pulled ______ for complete ejection and inflation of life raft.
through their full travel
If inflight evacuation of the aircraft is required and conditions permit, the order of preference for the bailout exits is:
Cargo door/ramp, paratroop doors, crew entrance door
Fuel for the APU is routed directly from the ____ fuel tank
No. 2
When the APU FIRE handle is pulled, the following occurs:
Fire extinguishing system directional flow valve is positioned, control power to the APU start circuit is interrupted, APU fuel supply shutoff valve is closed. (All answers are correct)
Normal flap operation is powered by the:
Utility system
Emergency lowering of the nose gear is powered by which hydraulic system?
Aux
The MC-130J has ____ portable oxygen bottles
4
If a parachutist is towed following a ramp exit, it will be necessary to _____
partially rewind the static line retriever to reach the static line for cutting.
What amount of F/ODS protection is provided in BIU backup mode?
Fire detection and fire suppression (a and b)
The max continuous APU EGT is:
680 degrees C
True or False: If the M-1 timer keys are retracted at any time prior to the airdrop load leaving the aircraft, the load is not be airdropped and will be returned to Aerial Delivery to replace the timer block(s)
True
After a FIRE handle has been pulled, the agent should be discharged when _________
any other indication or malfunction is suspected that requires fire extinguisher agent / an indication continues after the fire handle has been pulled. (both a and b)
True or False: For an emergency APU start, the APU fire detection system is operative. The FIRE handle will operate normally.
True
True or False: Failure to reset CARGO JETTISON switches to NULL will prevent activation of locks using the LOCKS switch.
True
Before attempting to jettison, the airplace CG should be computed to ensure __________ and that cargo is jettisonable in accordance with the Cargo Height Jettison Limit chart.
CG will be maintained within normal limits for landing
Jettison of large heavy palletized or unpalletized cargo resting on the floor should be attempted as a last resort only. Heavy cargo resting on the floor ________
may move slowly, may become misaligned, could cause out of limit CG travel and loss of flight control. (all of the above)
When passengers are carried and the use of additional life rafts is required, basic crewmembers will board:
the assigned life raft
When either the CREW DOOR OPEN (W) or RAMP OPEN PRESSURIZED (W) ACAWS message is displayed, notify ______
crew and passengers to fasten seat belts
The alarm bell signal for Ground Evacuation is:
1 long sustained ring
What should you do with cargo for a Gear-Up landing?
consider jettisoning
If landing with nose gear retracted and main gear down, what do you do with cargo, if applicable?
if cargo can be safely moved, shift it to the most aft limit practicable
Variable pallet configurations preclude jettisoning loads under some circumstances. Outsized and bulky cargo on pallets will cause the aircrew to:
secure the questionable gear by any means available
True or False: For a parachutist towed after exit from the cargo ramp and door, the first priority is to cut the parachutist free if consciousness is indicated.
True
True or False: According to the ditching chart, the loadmaster will obtain an emergency exit light/flashlight, water jug, and exit through the aft escape hatch and inflate life vest.
True
Crewmembers in the cargo compartment will use the _________ for exit after ditching
center or aft escape hatch
The fire and overheat detection system monitors for indications of _____, ______, and ______
fire, overheat, smoke
Do not conduct _____ transfer and ______ operations at the same time
inter-tank; crossfeed
After rapid decompression: the loadmaster should make an inspection of the fuselage during descent (using _______ and wearing ________) to determine what caused the decompression and the extent of any damage.
a walk-around oxygen bottle; a restraining harness or parachute
The APU EGT shall be allowed to stabilize and cool down for a minimum of ______ without a bleed air load before placing the APU switch to STOP.
2 minutes
For the loadmaster to communicate through the GHC, the loadmaster's headset must be plugged into the ICS override panel HIU and the OVRD/NORM switch selected to _____
OVRD
Prior to raising the ramp, ensure ______
the ramp locks are retracted and the ramp seal area is clear
True or False: With the center escape hatch ladder installed, it is impossible to exit the airplane form the center overhead cargo compartment escape hatch.
True
The last 5 feet are the most crucial for the towed parachutist. An oscillating parachutist usually strikes the aircraft head first. If the parachutist is oscillating violently, _______, then continue with the retrieval.
Stop the retrieval momentarily to allow stabilization
The nose gear is normally supplied with hydraulic fluid under pressure by the utility supply system; however, during an emergency it can be supplied by the __________ (for extension only)
Auxiliary hydraulic system
If a fire is near an oxygen component or there is a possibility that the oxygen could increase the fire, consider ____________, provided portable oxygen bottles are adequate for the situation
closing the oxygen manual shutoff valve
Do not operate the airplane without serviceable batteries. Power would not be available to operate the:
fire extinguisher system and alarm bells, standby instruments and emergency exit lights extinguish, utility lights and smoke detectors (all of the above)
The alarm signal to prepare for bailout is what?
3 short rings
An active UNCOMMANDED CHG CAWS message will inhibit the ECHS system from being armed for airdrop. To clear the UNCOMMANDED CHG CAWS message __________
Save the program as required and cycle power for the MFCD
Do not activate the _____ until the area around the _____ is clear of people and equipment.
air deflector doors; door
Three short rings followed by one long sustained ring on the emergency alarm bell means ______
bailout
Towed parachutists indicate consciousness and that reserve parachute is ready by ________
maintaining a tight body position with both hands on reserve parachute
During training, out the paratroop door, the first priority is to ________ the parachutist
retrieve, whether the parachutist is conscious or unconscious
For a parachutist towed after exit from the cargo ramp and door, the first priority is to ______
cut the parachutist free if consciousness is indicated
On CRRC drops, parachutists will line up along side the load, but will not move aft of FS _____ until the load starts to move aft.
737
Ensure the RAMP/DOOR FULL light on the _________ is illuminated. For airdrop missions, failure of the FULL light and ramp and door FULL OPEN light to illuminate with be considered a no-drop condition
flight station ADS panel
For sequential/multiple aerial deliveries, CG movement up to _____% MAC forward of the normal forward limit is permitted between drops.
7
Emergency APU start is required when no ___ power is available, battery is voltage is less than ___ VDC, and it is necessary to depart.
AC; 22
___ portable battery operated NVIS emergency exit lights are installed on stationary terminal blocks located near each normal or emergency exit.
8
____ hand operated fire extinguishers are provided for fighting interior fires.
4
There are ____ smoke detector units installed. They are located ______
4; 3 in the cargo compartment and 1 in the underdeck avionics compartment
Locks in the LOCKED position with extraction parachute force applied against them will not _____ or _____
ARM; RELEASE
If the extraction chute(s) are fully inflated and the locks fail to release, verify the locks are still in the armed state and place the appropriate RECP CARGO JETTISON switches to ARM for ____ second(s) and then RELEASE (aft to forward)
1
For jettisoning purposes, the max allowable cargo height-inches is measured from ______
the bottom of the pallet
The aft center of gravity limit for a partially loaded parked airplane is _____
five percent MAC aft of the aft center of gravity for flight
It may be necessary to set the __________ prior to winching heavy loads
parking brake
True or False: Ensure the Nose Landing Gear is not chained and the NLG pin is installed prior to loading/offloading
True
When, if ever may tires be deflated for vehicle loading operations?
when authorized in specific loading procedures
Close the paratroop doors when equipment/cargo more than ____ inches high and ___ inches wide at the top is being loaded or when other high-profile cargo is being loaded off the centerline.
100; 80
Vehicles/items loaded on the airplane ramp for flight will be positioned so the filler cap/spout is towards the _______ when it is closed and locked
higher end of the ramp
For Type V platform extracted airdrop loads, ensure clevises installed in the tandem holes of the multipurpose links are secured in the horizontal position to preclude clevises from dragging along the restraint rails and floor during extraction. Clevises that do not remain in the horizontal position will be ____________
tied with 80-pound cotton webbing
On the RECP, the LOCKS switch is used to lock ______ cargo compartment locks _________ in the event of an emergency
all; simultaneously
When the LOCKS switch on the RECP is placed to the LOCKS ALL position, what happens to the aft holddowns and ramp locks?
aft holddowns and ramp locks are not affected
Before operating the ramp and door from the ramp control panel, ensure ______
flight station ADS RAMP/DOOR switch is in the off position, RECP RAMP/DOOR switch is in the OFF position, Ramp control panel door control handle and ramp control knob are in the neutral position.
It is recommended that pallets weighing less than _____ pounds not be jettisoned
2500
"The CAWS message ""ADS ARMS IN GND POSITION"" appears on the MFCD when _______"
the ramp and door switch was activated in flight and the ADS latch pawls are not in the engaged (ADS) position
The center vertical restraint rails provide _____ Gs vertical restraint and lateral guidance for ___-inch wide container delivery system skid boards
3; 48
True or False: All load that are approved for aerial delivery shall meet all require load restraint criteria. Tiedown patterns are pre-calculated and shall not be changed or altered unless specifically authorized by the applicable rigging manual for the load.
True
Using a method that will not slip, secure _____ to the extraction line approx 12 inches above the tiedown recess and attach to itself in a manner than can be pulled tight.
a piece of 550 cord
The loadmaster will ensure the bomb rack is locked by checking ______
the release lever locking arm must engage a minimum of 50% of the lower surface of the solenoid pin, visually check to ensure the 3 buttons on the left side of the bomb rack are in the full down position. (both a and b)
Sequential airdrop platforms or two airdrop platforms to be dropped on separate passes must not be placed in a position in which both ______________, unless mission requirements dictate.
will be restrained by electric locks controlled by a single RECP CARGO JETTISON switch
Do not jettison _________ or perform non-personnel airdrops with the paratroop door rail sections removed. EXCEPTION: _________________
pallets/platforms; non-CVR single stick CDS airdrop
When dropping CDS bundles weighing 501-1600 pounds, a ______-inch thick skidboard _____ be used.
3/4; may
How much restraint will be provided if a bolt is loose or missing in a tiedown D-ring strap?
shall not be used for cargo restraint
The internal snatch blocks are designed for a rated load of ________ pounds and are to be used with _____ inch diameter cable.
13,000; 3/8
When the MFCD is ON and the CARGO JETTISON switches are used to release or jettison a pallet/platform, the switch must stay in the _______position until the load is clear or a malfunction occurs. Placing the switch in the NULL position will cause the cargo floor locks to default to the ______ position.
RELEASE; ARMED
The Lucas winch consists of a winch assembly, a control pendant and two control pendant electrical cables and develops a pulling power of ________ pounds
6500
When the overboard vent is used to vent _______ or other contaminants, a write-up shall be entered in the Airplane Form
fuel