1/28
Looks like no tags are added yet.
6-minute walk test
distance walked in six minutes; also record measures such as heart rate, symptoms and rests if required
Incremental Shuttle Walk Test (ISWT)
distance, level or shuttle reached, and final walking speed
Endurance Shuttle Walk Test (ESWT)
time or distance completed at the set pace
YMCA cycle test
workload and heart-rate response across stages; used to estimate VO₂max.
Step test
recovery heart rate, or the protocol’s specified score
12-minute walk/run test
distance covered in 12 minutes
Beep test
final level/shuttle and estimated VO₂max, if the protocol includes that calculation.
Quiet-stance test
time maintained in each stance condition, up to the test limit; record sway, steps or need for support
Tandem or single-leg stance
time held; also record errors or support used
Y-Balance / Star Excursion test
reach distance in each direction, often normalised to leg length; a composite score may also be calculated
Joint-position-sense test
error between the target position and the position reproduced, usually in degrees
Marsden pull test
number of steps or assistance needed to recover balance, or the protocol’s recovery level
BESS
number of balance errors; more errors indicate poorer performance.
Functional Reach test
distance reached forward, usually cm
Goniometry / ROM test
joint range, recorded in degrees.
Muscle-length test
range or position reached, recorded using the test’s specified measure.
EXAMPLES INCLUDE:
Hip flexion length assessment: lift up the opposite leg and see whether the leg on the surface stays flat or if it lifts up
Butterfly hold test: Tests the length of the inner thighs. Sit on the floor with the soles of the feet together, asssessing whether the knees touch the ground
Wall angel: stand with your back to the wall. Press into the wall with shoulders abducted to 90 degrees and elbows flexed to 90 degrees. Observe how far the shoulders get back
Trunk rotation test: stand with arms extended and reach to a target behind you (rotating the trunk)
Toe touch test: hamstrings, calves and spine all incorporated
Sit and reach test: lumbar spine and hamstrings
Manual muscle test (MMT)
muscle grade, usually 0–5
Hand-held dynamometry
force produced, usually N or kg-force
Grip dynamometry
grip force, usually kg.
1RM test
greatest load lifted once, usually kg
Strength RM test
load lifted for the specified number of repetitions, e.g. 3–8RM
Muscular-endurance test
number of repetitions completed at the set load or until the stopping point
Wall sit
time held, usually seconds
Calf-raise test
number of technically acceptable repetitions
Single-leg squat test
movement quality, such as knee control, pelvic control and squat depth; sometimes repetitions or score, depending on the protocol
Hop test
hop distance or time, depending on the test. For side-to-side comparison, compare the two legs or calculate a symmetry index
Vertical jump test
jump height; peak power in watts if body mass and the required calculation are included
Figure-8/agility run
time to complete the course; note errors if the protocol includes them
Step-up test
repetitions or time completed, depending on the protocol.