2025 Cisco 300-430 dumps exam questions

Share the latest information youeed to know for the Cisco 300-430 exam and provide the latest dumps exam questions and answers

300-430 ENWLSI Overview

Implementing Cisco Enterprise Wireless Networks (300-430 ENWLSI) v1.1 is a 90-minute exam that certifies a candidate's knowledge of wireless network implementation, including Cisco FlexConnect, Quality of Service (QoS), Multicast, advanced location services, security for client connectivity, monitoring and device hardening.

300-430 ENWLSI v1.1 Exam Topics

The following topics are general guidelines for the content likely to be included on the exam. However, other related topics may also appear on any specific delivery of the exam. To better reflect the contents of the exam and for clarity purposes, the guidelines below may change at any time without notice. 

Download Complete List of Topics in PDF format

• FlexConnect | 15%

• QoS on a Wireless Network | 10%

• Multicast | 10%

• Location Services | 10%

• Advanced Location Services | 10%

• Security for Wireless Client Connectivity | 20%

• Monitoring | 15%

• Device Hardening | 10%

2025 Cisco 300-430 dumps exam questions online share

Question 1:

A network engineer performed a new deployment of Cisco DNA Center. The engineer discovered and provisioned all APs and converted them to fabric. The SSIDs were created, and the APs were allocated to the respective floors, but the SSIDs are not being seen on the floors. What must be configured to establish this connectivity?

A. Map the pools to the SSIDs.

B. Configure RADIUS for the SSIDs.

C. Enable all radios on the APs.

D. Add the users in Cisco ISE.

Correct Answer: C

Question 2:

Refer to the exhibit.

A network administrator deploys the DHCP profiler service in two ISE servers: 10.3.10.101 and 10.3.10.102. All BYOD devices connecting to WLAN on VLAN63 have been incorrectly profiled and are assigned as unknown profiled endpoints. Which action efficiently rectifies the issue according to Cisco recommendations?

A. Nothing needed to be added on the Cisco WLC or VLAN interface. The ISE configuration must be fixed.

B. Disable DHCP proxy on the Cisco WLC.

C. Disable DHCP proxy on the Cisco WLC and run the ip helper-address command under the VLAN interface to point to DHCP and the two ISE servers.

D. Keep DHCP proxy enabled on the Cisco WLC and define helper-address under the VLAN interface to point to the two ISE servers.

Correct Answer: C

https://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan- controllers/110865-dhcp- wlc.html

Question 3:

DRAG DROP

The network management team in a large shopping center has detected numerous rogue APs from local coffee shops that are broadcasting SSIDs. All of these SSIDs have names starting with ATC (for example, ATC302, ATC011, and ATC566). A wireless network engineer must appropriately classify these SSIDs using the Rogue Rules feature. Drag and drop the options from the left onto the categories in which they must be used on the right. Not all options are used.

Select and Place:

Correct Answer:

Question 4:

An engineer added more APs to newly renovated areas in building. The engineer is now receiving Out-of-Sync alarms on Cisco Prime Infrastructure. Which two actions resolve this issue? (Choose two.)

A. Manually synchronize from Cisco Prime Infrastructure.

B. Manually synchronize from MSE.

C. Enable automatic synchronization on Cisco Prime Infrastructure.

D. Enable automatic synchronization on MSE.

E. Add new APs to maps on Cisco Prime Infrastructure.

Correct Answer: BD

ref: https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-5/user/guide/bk_CiscoPrimeInfrastructure_3_5_0_UserGuide/bk_CiscoPrimeInfrastructure_3_5_0_UserGuide_chapter_0100110.html#con_1301578:~:text=NEs% 20with%20MSE-,Set%20Up%20Synchronization%20Between%20MSE%20Databases%20and%20Product%20Database,-Manual%20synchronization%20of

Question 5:

Refer to the exhibit.

What is the reason that the wireless client cannot get the RUN state?

A. It has no communication with Cisco ISE.

B. An authentication error has occurred.

C. It is not getting the IP address.

D. Because of central switching, the AP must reach the Cisco ISE directly.

Correct Answer: C

Question 6:

Which role does an engineer configure for administrative access to the wireless infrastructure, using Cisco ISE, to allow configuration of the WLC syslog configuration?

A. MANAGEMENT

B. SECURITY

C. CONTROLLER

D. WIRELESS

Correct Answer: A

https://www.ibm.com/docs/en/dsm?topic=controllers-configuring-syslog-cisco-wireless-lan-controller https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/91631-uwn-tacacs-config.html#:~:text=should%20be%20referred.-,Authorization,-Authorization%20is%20task

Question 7:

A network engineer is configuring a Cisco AireOS 8.2 WLC, Cisco MSE, and Cisco PI with Cisco 3700 Series APs and Cisco Hyperlocation modules. The engineer configures and enables a WLAN with Hyperlocation. During testing, the engineer notices that the Hyperlocation module cannot be seen on the WLC. Which action resolves the issue?

A. Configure the APs to be in monitor mode.

B. Enable Hyperlocation in the Global Configuration settings of the WLC.

C. Add the key hash that is used to add the Hyperlocation module to the WLC.

D. Enable the NTP server that is connected to the Hyperlocation module.

Correct Answer: C

Question 8:

An engineer is following the proper upgrade path to upgrade a Cisco AireOS WLC from version 7.3 to 8.9. Which two ACLs for Cisco CWA must be configured when upgrading from the specified codes? (Choose two.)

A. Permit 0.0.0.0 0.0.0.0 UDP any any

B. Permit 0.0.0.0 0.0.0.0 any DNS any

C. Permit 0.0.0.0 0.0.0.0 UDP DNS any

D. Permit 0.0.0.0 0.0.0.0 UDP any DNS

E. Permit any any any

Correct Answer: CD

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/115732-central- web-auth-00.html

Question 9:

An engineer must implement a BYDD policy with these requirements:

1.

Onboarding unknown machines

2.

Easily scalable

3.

Low overhead on the wireless network

Which method satisfies these requirements?

A. triple SSID

B. open SSID

C. dual SSID

D. single SSID

Correct Answer: D

https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Borderless_Networks/Unified_Access/BYOD_Design_Guide/BYOD_Wireless.html

Question 10:

A wireless engineer needs to implement client tracking. Which method does the angle of arrival use to determine the location of a wireless device?

A. received signal strength

B. triangulation

C. time distance of arrival

D. angle of incidence

Correct Answer: D

The Angle of Arrival (AoA) technique, sometimes referred to as Direction of Arrival (DoA), locates the mobile station by determining the angle of incidence at which signals arrive at the receiving sensor. Geometric relationships can then be used to estimate location from the intersection of two lines of bearing (LoBs) formed by a radial line to each receiving sensor, as illustrated in Figure 2-5. In a two-dimensional plane, at least two receiving sensors are required for location estimation with improved accuracy coming from at least three or more receiving sensors (triangulation).

Reference: https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/WiFiLBS- DG/wifich2.html

Question 11:

An engineer is implementing RADIUS to restrict administrative control to the network with the WLC management IP address of 192.168.1.10 and an AP subnet of 192.168.2.0/24. Which entry does the engineer define in the RADIUS server?

A. administrative access defined on the WLC and the network range 192.168.2.0/255.255.254.0

B. NAS entry of the virtual interface and the network range 192.168.2.0/255.255.255.0

C. shared secret defined on the WLC and the network range 192.168.1.0/255.255.254.0

D. WLC roles for commands and the network range 192.168.1.0/255.255.255.0

Correct Answer: A

Question 12:

An IT administrator deploys Cisco 2802i APs in all office locations, including main campus and branch offices. The WLC that manages the APs is located at the data center on the main campus. The APs on the main campus are configured to use Local mode and the APs in the branches use FlexConnect mode. Which configuration must be applied to the APs for corporate devices on the main campus to be mapped to the local LAN switch on different VLANs according to the VLAN tag ID and WLAN?

A. Enable Central DHCP Processing.

B. Disable FlexConnect Local Auth

C. Enable FlexConnect Local Switching.

D. Disable VLAN-based Central Switching.

Correct Answer: A

Question 13:

Refer to the exhibit.

An engineer must connect a fork lift via a WGB to a wireless network and must authenticate the WGB certificate against the RADIUS server. Which three steps are required for this configuration? (Choose three.)

A. Configure the certificate, WLAN, and radio interface on WGB.

B. Configure the certificate on the WLC.

C. Configure WLAN to authenticate using ISE.

D. Configure the access point with the root certificate from ISE.

E. Configure WGB as a network device in ISE.

F. Configure a policy on ISE to allow devices to connect that validate the certificate.

Correct Answer: ACF

A. Configure the certificate, WLAN, and radio interface on WGB. --> That\'s true

B. Configure the certificate on the WLC. --> Nope, the WLC is the authenticator, it is neither authenticated or needs to authenticate anything C. Configure WLAN to authenticate using ISE. --> True, on the controller the SSID to which the WGB will connect must be configured, and broadcasted by the LAP D. Configure the access point with the root certificate from ISE. --> If they are talking about the WGB access point, then that\'s true, the root certificate that signed ISE certificate needs to be installed in the WGB AP E. Configure WGB as a network device in ISE. --> That\'s surely wrong. The WGB is not the authenticator in the dot1x process. It is the client. The controller is the authenticator. F. Configure a policy on ISE to allow devices to connect that validate the certificate. --> As I understand it, in some ways, that\'s true. We need to create an authentication/authorization policy on ISE so that the WGB AP will be authenticated by ISE based on the its certificate.

Question 14:

An enterprise has recently deployed a voice and video solution available to all employees using AireOS controllers. The employees must use this service over their laptops, but users report poor service when connected to the wireless network. The programs that consume bandwidth must be identified and restricted. Which configuration on the WLAN aids in recognizing the traffic?

A. NetFlow Monitor

B. AVC Profile

C. QoS Profile

D. Application Visibility

Correct Answer: D

Question 15:

Which CLI command do you use to shut down the 2.4 GHz radio of the Floor1_AP1 AP on a Cisco 3850 Switch?

A. ap name Floor1_AP1 dot11 shutdown 24ghz

B. ap name Floor1_AP1 dot11 5ghz shutdown

C. ap name Floor1 AP1 dot11 24ghz shutdown

D. ap name Floor1_AP1 shutdown dot11 24ghz

Correct Answer: C

…

Finally I want to tell you:

The Leads4pass 300-430 dumps exam material contains 300latest exam questions and answers. Use https://www.leads4pass.com/300-430.html to download the complete material to help candidates successfully pass the Implementing Cisco Enterprise Wireless Networks (ENWLSI) exam.