Electrical Quantities and Basic Circuits Study Notes
Electrical Theory
Atomic Structure: Electrons orbit the nucleus in shells holding specific numbers of electrons.
Conductors, Insulators, & Semiconductors:
Conductors allow free electrons to pass readily because outer shell electrons are held with minimal force.
Insulators hold electrons with relatively strong force, preventing easy movement.
Semiconductors are made from materials containing 4 valence electrons.
Diode Operation:
Carrier exchange at the P-type and N-type junction creates a thin depletion region.
Forward bias permits electron flow from cathode to anode; reverse bias prevents electron flow.
Manufacturers mark the cathode end using bands, schematic symbols, physical size, or bevels.
Energy & Voltage Production:
Forms of energy used to produce electricity include coal, nuclear power, natural gas, and oil.
Electrical energy outputs include motion, light, heat, sound, and visual outputs.
Voltage production methods: electromagnetism, heat, light, chemical reaction, pressure, and friction.
DC voltage sources include batteries, photovoltaic cells, and rectified AC; output ranges from pure DC to half-wave DC.
AC voltage consists of one positive and one negative alternation per cycle, available as single-phase () or three-phase ().
Current, Resistance, & Wire Sizing:
Current capacity of a cell or battery depends directly on its size.
Smaller American Wire Gauge (AWG) numbers represent greater cross-sectional area and heavier wire.
Ohm's Law:
Defines the relationship between voltage ( in ), current ( in ), and resistance ( in ):

Electrical Circuits
Circuit Types:
Series Connection: Two or more components connected so there is only one path for current flow.
Parallel Connection: Two or more components connected so there is more than one path for current flow.
Series/Parallel Connection: A combination of series-connected and parallel-connected components.
Circuit Applications:
Heating Element Circuits: Utilize series, parallel, or series/parallel connections to achieve various heat outputs.
Photovoltaic Cells: Connected in series to increase voltage output, or in parallel to increase current output.
Magnetism, Inductance, and Capacitance
Theory of Magnetism:
Molecular Theory of Magnetism: All substances consist of molecular magnets that can be arranged in an organized (magnetized) or disorganized (demagnetized) manner.
Electromagnetism: Discovered by Hans C. Oersted in 1819; electric current flowing through a conductor creates a surrounding magnetic field.
Flux Density & Coil Strength:
Flux Density: Equal to total magnetic lines of force (maxwells) passing through a section, measured in gauss.
Field Strength: Increased by increasing voltage, increasing the number of turns in a coil, or inserting an iron core.
AC Reactive Properties:
Phase Shift: Occurs when voltage and current do not reach maximum amplitude and zero level simultaneously.
Inductive Reactance (): Opposes current flow in AC circuits; current is directly proportional to applied voltage and inversely proportional to
Capacitive Reactance (): Current leads voltage by up to in capacitive circuits; decreases as capacitance () or frequency () increases.
Electrical Power & AC Calculations
Power Formula:
Defines the relationship between true power ( in ), voltage ( in ), and current ( in ):

Power Types & Efficiency:
True Power (): Actual power consumed; less than apparent power when a phase shift exists.
Apparent Power (): Product of total voltage and total current.
Reactive Power (): Power stored and returned to the circuit by inductive/capacitive loads.
Power Factor: The ratio of true power to apparent power. A running capacitor can be added to a motor to achieve a power factor of ( efficiency).
Impedance ():
Total opposition to current flow in AC circuits containing resistance and reactance ().
Calculated using modified Ohm's law:

Checkpoint Questions
1-1 Checkpoint:
What are the three fundamental particles contained in atoms?
Which particle has a negative charge?
What unit is used to measure resistance?
What device allows current to flow in only one direction?
What type of fuel is used to produce the most amount of electricity?
What electrical devices consume the largest share of produced electricity?
Voltage is measured in volts (), but what letter is used to represent voltage?
What device converts AC voltage to DC voltage?
What are the two types of AC voltage?
Current is measured in amperes (), but what letter is used to represent current?
What are the two types of current?
Resistance is measured in ohms (), but what letter is used to represent resistance?
If resistance is increased in a circuit, does current increase or decrease?
If is applied to a circuit that has a resistance of , how many milliamperes () will flow through the circuit?
If and are measured in a heating element, how much resistance (in ) does the heating element have?
1-2 Checkpoint:
What is the total voltage of six batteries connected in series?
If total is measured at the power supply that includes three resistors connected in series, how much current is flowing through each resistor?
What is the total voltage of six -rated batteries connected in parallel?
In a circuit that contains a , a , and a resistor connected in parallel, which resistor would have the largest amount of current flowing through it?
If six -rated photovoltaic cells connected in series are placed in parallel with another set of six identical cells in series, what is the total voltage?
For the same combination of photovoltaic cells, what is the total available current?
1-3 Checkpoint:
Does increasing the number of loops in a coil increase or decrease the electromagnetic field when current passes through the coil?
Inductance is measured in henrys (), but what letter is used to represent inductance?
Capacitance is measured in farads (), but what letter is used to represent capacitance?
Inductive reactance and capacitive reactance oppose a flow of current in a circuit and are stated or measured in what electrical unit?
In an AC circuit that includes a coil (inductance), is the voltage and current in phase or out of phase?
1-4 Checkpoint:
If are measured in a circuit, how much power (in ) is the circuit using?
If two and four lamps are connected into a parallel circuit, what is the total power (in ) used by the circuit?
If a string of sixty holiday lights are connected in series, what is the total power (in ) of all the lights?
What electrical unit is reactive power measured in?
What electrical unit is apparent power measured in?
What is the ratio between true power and apparent power called?