Alberta Basic Licence Drivers Assessment Study Guide
Speed Limits and Road Classifications
- Primary Highways Outside Urban Areas: Unless otherwise posted, the basic speed limit on a primary highway located outside a city, town, or village is 100km/h.
- School Zones (Urban): Speed limits in school zones are in effect on school days during the following hours: 8:00A.M. to 9:30A.M., 11:30A.M. to 1:30P.M., and 3:00P.M. to 4:30P.M..
- School Zones (Rural): In a rural area, the maximum speed permitted in a school zone at 9:00A.M. on a school day is 30km/h, unless otherwise posted.
- Playground Zones: These zones are in effect from 8:30A.M. to 1hour after sunset.
- Construction Zones: The speed limit in a construction zone must be obeyed at all times, regardless of whether workers are present or it is daylight.
- General Limits: Speed limit signs indicate the maximum speed permitted when conditions are favourable.
- Slow-Moving Vehicles: A "slow-moving vehicle" sign must be displayed on the rear of any vehicle that normally travels at speeds less than 40km/h.
The Alberta Licensing and Demerit Point System
- Suspension Thresholds:
- Fully Licenced Drivers: A non-learner, non-probationary driver is suspended after accumulating 15 demerit points.
- Graduated Driver Licensing (GDL): A learner with a Class 7 license is suspended upon accumulating 8 demerit points.
- Probationary Period: Under the GDL program, a person must serve as a probationary Class 5 driver for a minimum of 2years.
- Class 7 Driving Restrictions: Drivers with a Class 7 license are restricted from driving between the hours of Midnight and 5:00A.M..
- Passenger Restraints (Demerits): Under GDL, a driver will receive 2 demerits for having more passengers than there are seat belts.
- Parental Consent: A parent may withdraw a previously given consent for a person under 18years of age, provided the individual is still under 18 and is not married or self-supporting.
- Road Test Denials: A driver examiner will refuse a road test if the vehicle is determined to be mechanically unsafe.
- Reporting Medical Conditions: The driver is legally obligated and responsible for reporting any medical condition, change in health, or physical disability that may affect their ability to drive.
Traffic Controls and Pavement Markings
- Traffic Lights:
- Green Arrow with Red Light: A driver may proceed when safe, without stopping, in the direction of the arrow.
- Flashing Red Light: A driver must stop and proceed only when it is safe to do so.
- Flashing Yellow Light: This signal means to proceed with caution.
- Steady Yellow Light: A driver must stop before the intersection unless the stop cannot be made in safety.
- Red "X" (Lane Control): This indicates that travel is not permitted in that specific lane.
- Pedestrian Signals: In an urban area, a pedestrian standing at a crosswalk with their arm raised at a right angle and pointing to the opposite curb indicates that drivers must stop and yield to the pedestrian.
- Pavement Markings:
- Single Solid White Line: Indicates that lane changing is not permitted between driving lanes in an urban area.
- Solid Yellow Line with Broken Yellow Line: If the broken line is on the driver's side, passing is permitted. If the solid line is on the driver's side, passing is not permitted.
- Large Painted "X": This marking on the pavement indicates a railway crossing ahead.
Rules of the Road: Intersections and Right-of-Way
- Uncontrolled "T" Intersections: When two vehicles approach at right angles at approximately the same time, the vehicle on the left must yield the right-of-way.
- Uncontrolled Intersections (General): These are intersections that have no traffic control signal lights or traffic signs.
- Yield Signs: Drivers must yield the right-of-way to traffic not facing the sign and all pedestrians in the intersection.
- Traffic Circles: A driver entering a traffic circle must yield to vehicles already in the traffic circle.
- Left Turns:
- At a steady green light, a driver must not cross the path of an approaching vehicle unless it is safe to do so.
- When turning left from a two-way road onto a one-way road, enter the lane nearest the curb on the left side of the one-way road.
- From a one-way road, left turns must be made from the left lane nearest the left curb.
- Right Turns on Red: Drivers may turn right at a red light if they stop first, ensure there is no prohibited sign, and yield to all traffic and pedestrians.
- Dual Turns: These are permitted only when indicated by pavement markings or traffic control signs.
Parking and Reversing Regulations
- Parallel Parking: The vehicle's wheels closest to the curb must be within a maximum distance of 30cm from the curb. Before leaving a parallel parking space on the right side of the road, the driver must shoulder check to the left.
- Angle Parking: The vehicle's front wheel must be within a maximum distance of 50cm from the nearest curb.
- Prohibited Parking Distances:
- Stop Signs: It is illegal to park within 5metres of a Stop sign.
- Fire Hydrants: The minimum legal parking distance from a fire hydrant is 5metres.
- Uphill Parking: On a two-way road with a curb, the front wheels should be turned to the left.
- Disability Parking: Parking in these reserved spaces is permitted only if the vehicle has a proper identifying placard or licence plate.
- Reversing Procedures:
- Straight Line: Place the left hand at the top of the steering wheel and look over the right shoulder through the rear window.
- Backing to the Left: Look over the left shoulder with occasional glances to the front to make steering adjustments.
Highway Maneuvers and Safety Procedures
- Merging:Acceleration Lane: A lane in a merge area for use by vehicles entering the highway. Drivers should watch for a gap in traffic, adjust to highway speed, and blend in smoothly.
Deceleration Lane: A lane where vehicles reduce speed when exiting a highway.
Weave Zone: A location on a highway where the entrance and exit lanes are close together. Vehicles slowing to exit must drive between vehicles accelerating to enter.
- Passing:
- It is never permitted to exceed the speed limit when passing another vehicle.
- When passing a large truck on a two-way highway, leave extra room before returning to your lane.
- When a "PASSING LANE AHEAD" sign is posted, slower moving vehicles should move into the right lane when safe.
- Following Distance: The "2-second rule" is used to judge a safe following distance and is accurate at any speed. If being followed too closely, slow down gradually to encourage the other vehicle to pass.
- Scanning: In urban areas, drivers should scan the road approximately 12 to 15seconds ahead.
- Emergency Vehicles: When approached by an emergency vehicle with sirens from any direction on a two-way road, drive as close as possible to the right curb or edge and stop.
- School Buses:Flashing Red Lights: Drivers must stop behind the bus and wait until the lights stop flashing.
Flashing Amber Lights: This is a warning that the alternating red lights will soon activate; drivers should be prepared to stop.
Handling Hazards and Environmental Conditions
- Skid Recovery: Drivers should steer in the direction they want the front of the vehicle to go. Most skids are attributed to driver error.
- Braking (Non-ABS): "Threshold braking" involves applying even force to the point just before the wheels lock, easing off slightly if they do. For a normal smooth stop, apply pressure, ease off slightly before stopping, then re-apply.
- Night Driving:Headlights: Must be dimmed at a minimum distance of 150metres when approaching another vehicle from behind.
Over-driving Headlights: This occurs when a driver travels at a speed that does not permit them to see an object in time to stop.
Visibility: Use low beam headlights in fog, smoke, or snow.
- Nighttime Definition: The period beginning 1hour after sunset and ending 1hour before the following sunrise.
- Off-Road Recovery: If the right tires travel off the pavement, keep a firm grip on the steering wheel, ease off the gas, and gradually return to the paved portion.
- Log-Haul Trucks: It is unsafe to pass a loaded log-haul truck that is turning because a danger zone exists where the overhanging logs could block all highway lanes.
- Railway Crossings: If lights and bells are activated, drivers must stop at least 5metres from the nearest rail.
Definitions and Specific Legal Requirements
- Parking Lane: Defined as the portion of a primary highway between the edge of the roadway to the right of the direction of traffic and the nearest solid white line (not the centre line).
- Shoulder Checking: The act of glancing towards the blind spot in the direction the driver intends to move.
- Collision Reporting: Drivers must report collisions to the police if there are injuries, deaths, or if the combined damage to all vehicles and property exceeds $1000.
- Seat Belts: Alberta law requires that seat belts be worn properly at all times. It is the driver’s responsibility to ensure all passengers under the age of 16years are properly restrained.
- Funeral Processions: Drivers must yield the right-of-way and must not break through the procession.
- Head Restraints: When raised to the proper position, the centre of the restraint is level with the top of the ears.
- Exiting Parking Lots: A vehicle exiting a parking lot onto a roadway must come to a complete stop.
Road Sign Identification Guide
- Dangerous Goods Route: Identification of routes specific to vehicles carrying dangerous materials.
- Slippery When Wet: Indicates the road surface may be lose traction in wet conditions.
- Concealed Intersection: Warning of an intersection on the right that may not be easily visible.
- Divided Highway Ends/Begins: Indicates changes in the highway structure regarding the separation of opposing traffic.
- School Zone vs. School Area: Differentiates between areas where a school is nearby (School Area) and where specific speed regulations apply (School Zone).
- Hazard Marker: Used to indicate physical obstructions or changes in the roadway layout.
- Added Lane (Free Flow): Indicates a new lane is added to the highway, allowing for merging without stopping.
- Primary Highway Route Marker: Used to identify the route number and direction of primary highways.
- Construction Signs: Examples include "People Working Ahead," "Detour Ahead," and "Flag Person Ahead."