Aircraft Ice and Rain Control Systems

Windshield Ice and Rain Protection Systems

  • Windshield Ice Prevention (AM.II.L.K3):

    • Modern jet transport airplanes prevent ice from forming on the windshield by utilizing an embedded electrical heater element.
    • Electric current passes through the embedded heating element to produce heat, which maintains windshield temperature and prevents ice accumulation.
  • Windshield Rain Removal Methods (AM.II.L.K7):

    • Compressor Bleed Air Blast: Rain is blown off the windshield by directing a high-velocity blast of compressor bleed air across the outer surface.
    • Mechanical Windshield Wipers: Rain is mechanically wiped away using windshield wipers driven either electrically or hydraulically.

Pneumatic Deicer Boot Operating Principles and Sequences

  • Operating Timing Relative to Ice Formation (AM.II.L.K4):

    • Pneumatic deicer boots are deicing systems rather than anti-icing systems; they are not operated until ice has already formed over them.
    • When the boot inflates, the expansion breaks the accumulated ice, allowing the airstream flowing over the airfoil to blow the shattered ice away.
  • In-Flight Hold-Down Mechanism:

    • During normal flight when deicing is not actively cycling, pneumatic deicer boots are held down flat against the wing and tail leading edges by continuous suction.
  • Inflation Sequence within the Boot (AM.II.L.K4):

    • Standard pneumatic deicer boots contain three distinct internal inflation tubes: an upper tube, a center tube, and a lower tube.
    • The center tube inflates first.
    • The upper and lower tubes inflate together a specified number of seconds after the center tube.
  • Electronic Timer Function:

    • The electronic timer in a pneumatic deicer boot system regulates and controls the complete operating sequence and the specific time intervals between inflation stages.

Pneumatic Deicer Air Sources and System Components

  • Air Supply Sources for Inflation:

    • Turbine-Powered Aircraft: Pneumatic boots are inflated using bleed air taken directly from the turbine-engine compressor.
    • Reciprocating-Engine Aircraft (AM.II.L.K4): Air is supplied by an engine-driven air/vacuum pump, specifically tapped from the discharge side of the pump that powers the gyroscopic flight instruments.
  • Vacuum Pump Classifications (AM.II.L.K4):

    • Wet Vacuum Pump: Operates using steel vanes and requires engine oil to lubricate the vanes during operation.
    • Dry Vacuum Pump: Operates using self-lubricating carbon vanes and does not require any oil for lubrication.
  • Oil Separator Function (AM.II.L.K4):

    • Used exclusively in systems equipped with wet vacuum pumps.
    • Installed to remove lubricating engine oil from the pump discharge air before the compressed air is directed to the rubber deicer boots, preventing oil-induced deterioration of the rubber.

Installation, Cleaning, and Maintenance of Deicer Boots

  • Attachment to Leading Edges (AM.II.L.K4):

    • Adhesive Bonding: Modern installations are secured directly to the leading edge surfaces of aircraft wings and empennage using dedicated bonding adhesives.
    • Mechanical Fasteners (Older Aircraft): Attached using fairing strips, machine screws, and threaded Rivnuts.
  • Cleaning Procedures (AM.II.L.K4):

    • Rubber deicer boots must be cleaned by washing them with mild soap and water.
  • Cold Patch Repair Prerequisite:

    • Prior to performing a cold patch repair on a damaged deicer boot, the installed tension on the boot must be completely relieved.