Pulse Oximetry Clinical Notes

Preparation and Patient Assessment

  • Perform hand hygiene, ensure patient privacy, and verify patient identity using two identifiers (such as the armband).
  • Indications for pulse oximetry include healthcare provider orders or clinical assessment of altered oxygen saturation, including:
    • Adventitious breath sounds
    • Cyanotic nails, lips, mucous membranes, or skin
    • Restlessness and difficulty breathing

Site Selection and Positioning

  • Select an appropriate sensor site: earlobe, forehead, bridge of the nose, or finger.
  • Avoid using a finger on the same side as an electronic blood pressure cuff, or any site with edema, altered skin integrity, or hypothermia.
  • Remove artificial nails on the target finger using acetone or polish remover.
  • Assess capillary refill at the selected site:
    • If capillary refill is greater than 3 seconds3\,seconds, choose an alternative site.
    • If capillary refill is less than 3 seconds3\,seconds, ensure the site is free of moisture.
  • Adapt sensor selection based on patient needs:
    • Tremors: Ear
    • Peripheral vascular disease: Ear or bridge of the nose
    • Active or obese patient: Disposable tape-on sensor
    • Latex allergy: Clip-on sensor (avoid disposable adhesive sensors)

Measurement and Monitoring

  • Instruct the patient to breathe normally and attach the sensor.
  • Turn on the oximeter, establish a pulse waveform and intensity display, and obtain an audible beep.
  • Palpate and assess the radial pulse, comparing it directly to the oximeter pulse rate.
  • Maintain sensor placement until the digital reading is constant and the pulse display reaches full strength each cardiac cycle.
  • Normal heart rate range is 6060 to 100 beats per minute100\text{ beats per minute}.
  • Read the peripheral oxygen saturation (SpO2SpO_2) on the digital screen.
  • For continuous monitoring:
    • Preset and turn on alarm limits for SpO2SpO_2 and pulse rate based on patient condition or provider orders.
    • Inspect skin integrity under the sensor at least every 2 hours2\,hours.
    • Relocate the sensor at least every 4 hours4\,hours.

Discontinuation and Follow-Up

  • To discontinue monitoring or after intermittent measurement:
    • Remove the probe, turn off the oximeter, clean the probe, and store the sensor.
  • Perform hand hygiene.
  • Compare the SpO2SpO_2 measurement against baseline values and acceptable ranges.
  • Monitor and record SpO2SpO_2 during key clinical events:
    • Initiation or termination of oxygen therapy
    • Before and during sleep
    • Before and after suctioning
    • Occurrence of shortness of breath or chest pain
    • During physical activity