Electrical Voltage, Current Intensity, and Series Circuit Laws
Fundamentals of Electrical Voltage and Current
Required Equipment for Circuit Assembly:
- Lamp with its mounting support (lampe avec son support).
- Generator (pile, batterie, or power supply).
- Switch (interrupteur).
- connecting wires or cables.
Current Flow and Circuit Operation:
- The conventional direction of electric current (sens du courant) flows out from the positive terminal () and returns to the negative terminal () outside the generator.
- Electric current flows through the circuit when the switch is closed (interrupteur fermé).

- Generator Adaptation and Nominal Voltage:
- To ensure a lamp illuminates normally, one must select a generator adapted to the voltage of the lamp.
- Nominal Voltage (tension nominale): The voltage specified for normal operation of a dipôle.
- Example: A lamp rated at () has a nominal voltage of . It illuminates normally when powered by a generator.
- Over-voltage (sur-tension): Connecting a lamp to a generator places the lamp in over-voltage, carrying a risk of burning out (griller) because it receives too much energy.
- Illumination Comparison: A lamp rated at () shines brighter than a lamp rated at () under normal conditions.
Measurement of Electrical Voltage
Definition and Units:
- Electrical voltage is denoted by the variable .
- It is measured in Volts (symbol ).
Measuring Instrument and Connection Method:
- Voltage is measured using a Voltmeter, represented in circuit diagrams by the symbol a circle with the letter .
- A voltmeter is always connected in parallel / derivation (en dérivation) across the terminals of the component.
- Advantage of Parallel Connection: It leaves the main circuit intact; two additional wires are simply attached across the terminals (aux bornes) of the device whose voltage is being measured.
Generator Voltage Measurement Example:
- Measuring the voltage across the terminals of a generator using the range/scale (calibre ) yields (or ).
Measurement of Electrical Current Intensity
Definition and Units:
- Current intensity is denoted by the variable .
- It is measured in Amperes (symbol ).
Measuring Instrument and Connection Method:
- Current intensity is measured using an Ammeter, represented in circuit diagrams by the symbol a circle with the letter .
- An ammeter is always connected in series (en série) directly within the circuit loop.
Experimental Intensity Values:
- For a circuit powering a () lamp, the measured intensity is .
- For a circuit powering a () lamp, the measured intensity is .
Measurement and Behavior in Series Circuits
- Experimental Setup and Materials:
- Material: Bulb 1 rated () and Bulb 2 rated ().
- Objective: Construct a single series circuit containing both lamps powered by a direct current (DC) generator ( en continu).

Experimental Observations:
- The () lamp shines normally.
- The () lamp barely shines at all (ne brille quasiment pas).
- Component order is irrelevant: exchanging the physical positions of the lamps yields the exact same illumination behavior.
Explaining Observations through Voltage Measurements:
- To explain why one lamp shines normally while the other does not, voltmeters are connected in parallel across each component in the series circuit.

Measured Voltage Values in Series:
- Generator terminal voltage: .
- Voltage across () lamp: .
- Voltage across () lamp: .
- Addition check: .
Law of Additivity of Voltages in a Series Circuit (Loi d'additivité des tensions dans un circuit série):
- Rule: In a series circuit, the total voltage across the generator terminals is equal to the sum of the voltages across the terminals of all other components in the circuit.
- Mathematical Formula:
- Explanation of Lamp Behavior: The ( / ) lamp shines very faintly because a lamp must have a terminal voltage close to its nominal rated voltage to function normally. Receiving only across its terminals is far below its nominal voltage of .
- Position Independence: The voltage across any component in a series circuit is completely independent of its position/location within the circuit loop.