ICMP Ping and Traceroute Notes
ICMP Overview
- ICMP (Internet Control Message Protocol) is essential for network diagnostics.
- Used for sending echo-request and echo-reply messages.
- Provides feedback on IP packet processing issues.
Class Exercise - Module 13: PING vs. TRACEROUTE
- Objective: Compare ping and traceroute commands to understand their use cases.
Step #1: Ping from PC2 to PC4
- Outcome: Note the success/failure of the ping.
- Important to count ICMP replies received.
Step #2: Traceroute from PC2 to PC4
- Command:
C>Tracert 10.20.4.10 - Determine how many hops the ICMP packet goes through.
- Identify how to know the number of hops (usually by counting the listed routers).
Step #3: Analyze Results
- From Step #2 results, identify the Default Gateway of PC2.
- This gateway is essential for forwarding traffic to other networks.
Step #4: Additional PING Command
- On PC2, issue the ping command to IP
10.20.0.1 (Loopback 1 on R4). - Outcome: Note the failure and analyze potential reasons (e.g., misconfigured devices, network issues).
Step #5: TRACEROUTE Command Execution
- On PC2, issue command:
C>Tracert 10.20.0.1. - Outcome: If it fails, determine where troubleshooting should begin.
- Reasons could include routing tables or firewall settings.
ICMPv4 Destination Unreachable Codes
- Codes:
- 0: Network unreachable
- 1: Host unreachable
- 2: Protocol unreachable
- 3: Port unreachable
ICMPv6 Destination Unreachable Codes
- Codes:
- 0: No route to destination
- 1: Communication administratively prohibited (e.g., firewall configuration)
- 2: Beyond scope of source address
- 3: Address unreachable
- 4: Port unreachable
Summary
- Familiarize with ICMP message types and how to interpret ping/traceroute outputs.
- Understanding these protocols and codes is crucial for troubleshooting network issues efficiently.