Study Notes on Unsaturated Zone Processes and Hydrogeophysics
Introduction to Unsaturated Zone Processes
Definition of Vadose Zone: The vadose zone is the portion of the subsurface located above the water table. It is the primary site for mass and energy exchanges between the subsurface and the atmosphere.
Hydrological Significance:
Provides boundary conditions for atmospheric processes, including micro-meteorology and climatic changes.
Controls subsurface water migration and aquifer recharge rates, timing, and patterns through percolation.
Acts as a filter or reactor: Contaminants released near the surface are altered, retarded, or removed by biological, chemical, and physical processes before reaching aquifers.
Determines water availability for agriculture and acts as a driving mechanism for slope stability, flooding, and major engineering geology problems.
Complexity and Characterization:
Processes involve complex, non-linear dynamics.
Often ignored in practice or treated with simplified approximations due to limited data.
Requires accounting for natural variability of soil properties at multiple scales.
Challenges in Measurement:
Direct measurements (tensiometers for water pressure) are invasive and destructive.
Direct measurement of water content still requires soil sample recovery for laboratory analysis.
Drilling-based measurements lack sufficient spatial coverage for basin-scale investigations and disturb the soil, hindering the monitoring of transient processes.
Small-scale samples are difficult to use for describing representative field-scale properties.
Principles of Unsaturated Flow in Porous Media
Hydraulic Head (H): Flow is controlled by differences in hydraulic head, defined as the sum of pressure head and elevation head :
Water Retention Curve: The relationship between pressure head and volumetric water content (). A widely accepted model is the van Genuchten (1980) four-parameter relationship:
: Residual water content at very high (infinite) suction.
: Water content at full saturation (roughly equal to porosity).
: Parameter inversely related to mean soil grain size ().
: Exponent where larger values indicate a wider grain and pore size distribution.
Simplified form: Often assumes .
Hysteresis: The pressure-saturation curve varies between drainage (drying) and imbibition (wetting). Intermediate behavior is described as a scanning curve.
Darcy-Buckingham Law: Describes water flux () induced by a total head gradient:
: Unsaturated hydraulic conductivity at pressure head .
Richards' Equation: Combines Darcy-Buckingham law with mass conservation (assuming infinite air phase mobility):
: Spatial coordinates; : Time.
Petrophysical Constitutive Relationships
Electrical Conductivity ():
Archie's Law (Saturated): Bulk conductivity () is proportional to fluid conductivity () when fluid conductivity dominates:
Formation Factor (F): , where is a constant (theoretically 1) and is the cementation exponent (typically 1.0–2.5).
Generalized Law: Includes matrix conductivity ():
Unsaturated Archie’s Law: Accounts for water saturation ():
is an empirical exponent generally close to 2.
Waxman and Smits Model: Explicitly for shaly sandstones:
Time-Lapse Saturation Ratios: If surface conductivity is negligible:
Dielectric Constant (Permittivity, ):
Complex Refractive Index Model (CRIM): A volume averaging relationship:
: Exponent generally equal to .
: Dielectric constants of solid matrix, water, and air respectively.
Topp Model: Empirical relationship for effective permittivity and volumetric water content:
Generally applied unless soil has high clay content, magnetic susceptibility, or unusual porosity.
Shallow Vadose Zone Monitoring
Time Domain Reflectometry (TDR):
Measures propagation velocity of a voltage step along metal rods (10 cm to 2 m) to infer dielectric permittivity.
Can measure both water content and bulk electrical conductivity simultaneously.
TDR Case Study (Borden, Ontario): Experiments on fine-to-medium sand. Used varying rod lengths ().
Interval-Differencing Formula:
Error Note: Lateral variations in water content between probes can lead to non-physical results (e.g., unreasonably low water content at specific depths).
Surface Ground Penetrating Radar (GPR):
Pathways: Air wave, direct ground wave, critically refracted wave, reflected-refracted wave, and reflected wave.
Modes:
Single-offset profile: Fast mapping over large areas.
Wide Angle Reflection and Refraction (WARR): One antenna fixed, one moved.
Common Mid Point (CMP): Both antennas moved from a central point.
Irrigation Case Study (Turin, Italy): 200 MHz antennas. Infiltration front created a low-velocity layer. Estimated water content: 5% (dry soil) to 38% (wet soil). Front depth increased from to over time.
Mountain Slope Case Study (Montemezzo, Italy): Soil layer over bedrock acts as a refractive waveguide. Used f-k (frequency-wavenumber) domain transformation for dispersion analysis to estimate soil thickness ( to ) and water content.
DC Resistivity:
Vertical Electrical Sounding (VES): Progressively larger electrode spacing to determine vertical resistivity layers.
Electrical Resistivity Tomography (ERT): Computer-controlled multi-electrode switching for 2D/3D subsurface imaging.
Deep Vadose Zone Characterization
Borehole GPR Configurations:
Multiple Offset Gather (MOG): Detailed 2D velocity tomogram; slow acquisition.
Zero Offset Profile (ZOP): Fast 1D profile of average inter-borehole travel time.
Vertical Radar Profiling (VRP): Single borehole; transmitter at surface, receiver lowered into hole.
Deep Vadose Case Studies:
Eggborough, UK: Sherwood Sandstone. ZOP monitoring from Aug 1999 to Feb 2001. Calculated water travel time to water table as . Used Monte Carlo simulations to match GPR profiles with Richards' equation parameters.
Trecate, Italy (Oil Spill): Po river plain aquifer. Used VRP to monitor water table oscillations ( to below ground level). Identified lithological control at depth. VRP vertical resolution estimated at .
Hatfield, UK (Tracer Test): Injected of NaCl-water tracer. Monitored center of mass move downward. Sensitivity analysis identified field saturated hydraulic conductivity () of sandstone as .
Borehole ERT:
Electrodes installed in boreholes to enhance sensitivity at depth.
Plume Monitoring Example: Showed vertical migration and significant lateral spreading of tracer plumes.
Mass Balance Error: 50% under-prediction of injected volume due to limited sensitivity at the center of images between boreholes.
Research Outlook and Integration
Data Integration: Combining multi-source data (e.g., GPR and ERT) to improve resolution.
Hydrologic Calibration: Systematized use of geophysics to calibrate flow and transport models.
Spectral Induced Polarization (SIP): Potential use of multi-frequency induced polarization.
Analysis of Uncertainty: Increasing recognition of tomographic non-uniqueness and the limited resolution of imaging techniques.