application, assembly, & testing

Interplay Learning: Plastic Pipe and Tube Joining Methods

Introduction

  • This lesson focuses on solvent welding for plastic pipes and tubes, specifically ABS, PVC, and CPVC.

  • Key areas covered include the application of primer and solvent, assembly of the joint, and testing of the joint.

Primer Application for PVC

  • Required Materials: Ensure that the correct primer and cement are used based on the pipe material.

  • PVC Primer Use: Unlike ABS and CPVC, PVC requires priming before cementing.

  • Size Consideration: The dauber in the primer can must match the pipe or tubing size.

  • Dry Conditions: Ensure that the pipe is dry, and avoid working in moist environments unless the area can be protected.

Steps for Applying Primer:
  1. Preparation: Remove any manufacturer's packing or tape using a knife, as primer will not remove this.

  2. Cleaning: Although primer does clean to some extent, it will not remove significant debris; clean the pipe first if dirty.

  3. Chemical Interaction: Primer contains specific chemicals that prep the surface for cement adhesion, not just cleaning.

  4. Code Compliance: Some jurisdictions might require a colored primer that will stain the pipe to verify primer use during inspections.

  5. Application Technique: Apply primer with 5 to 7 complete revolutions around:

    • The inside of the fitting.

    • The outside of the pipe.

  6. Working with Colored Primer: Be cautious of pipe orientation for aesthetic consistency, as improper application leaves a messy appearance, reflecting poorly on craftsmanship.

Application of Solvent Cement

  • Selection of Cement: Always choose the appropriate cement for the material; interchanging cements can lead to failures.

  • Properties of Cement: Cements vary in viscosity based on temperature and fitting sizes.

Steps for Applying Solvent Cement:
  1. Pre-Insertion Preparation: Verify the direction of directional fittings before inserting the pipe.

  2. Cement Application: Apply cement to the outside of the pipe wall:

    • Make about 5 to 7 revolutions to ensure coverage.

    • Ensure sufficient cement is applied within the fitting without overfilling to avoid excess expulsion.

  3. For Larger Pipes: With pipes larger than 4 inches, mark the piping to assist with alignment during assembly.

Assembling the Joint

  • Joining Process: Insert the pipe into the fitting and rotate it a quarter turn.

  • Pressure Application: Maintain applied pressure pushing the pipe into the fitting for at least 90 seconds.

  • Factors Influencing Assembly: The required time to maintain pressure varies depending on environmental conditions:

    • Cooler temperatures and lower humidity provide more time for adjustment.

    • After the pressure time, use a rag to remove any surplus cement for aesthetic purposes, as the cement dries rapidly.

  • Correct Alignment: Ensure proper alignment is crucial; misalignment can lead to assembly difficulties and ineffective connections.

Testing the Bond

  • Instructions Compliance: Always follow manufacturer's instructions and code specifications for testing.

  • Temperature Consideration: Testing times may be extended in colder conditions.

  • Safety Warning: Never test plastic pipes with air or gas due to high risk of explosion and creation of dangerous shrapnel.

Common Causes of Leaks
  • Leak Factors: The following can lead to leaks in the piping:

    • Partial insertion of pipe into the fitting.

    • Installation in wet environments.

    • Misalignment of pipes and fittings.

    • Insufficient or excessive cement application (excess leading to cavitation).

    • Incorrect cement type used.

    • Poor cuts resulting in uneven pipe lengths.

Conclusion

  • This lesson has provided essential insights into the processes of applying primer and cement, assembling, and testing joints for PVC, ABS, and CPVC pipes. Understanding these steps ensures durability and effectiveness in pipe joint applications.

  • Further learning will continue in the next lesson, aiming for enhanced proficiency in plastic pipe joint techniques.