Chapter 15 Lecture Notes – Coastal Environments, Tides, and Waves

Scope and Lecture Logistics

  • Chapter 15 focuses on coastal environments; the formal textbook section on long-term sea-level change is not tested (only daily tidal change is needed).
  • Test and homework questions come solely from lecture content.

Core Vocabulary & Definitions

  • Coast – the physical interface where land meets water; processes on both sides shape its features.
  • Coastal zone – combined strip of land and adjoining water that borders the shoreline; width is highly variable.
  • Littoral zone – the entire coastal + inter-tidal area.
  • Inter-tidal zone – vertical band between the high-tide line and low-tide line.
  • Backshore – highest, landward part of a beach; seldom submerged (only during storms or very large waves).
    • Berms: nearly flat, storm-built sand platforms within the backshore.
  • Foreshore – slope seaward of the backshore; alternately submerged at high tide and exposed at low tide.
  • Inshore (nearshore/sub-tidal) – seaward of the low-tide line; almost always submerged except during extreme events (e.g., tsunami).
  • Dunes – wind-built ridges landward of the backshore; provide storm/wind protection for inland areas.
  • Wave terminology
    • Crest – highest point • Trough – lowest point
    • Wave height (H) – vertical distance crest ↔ trough
    • Wavelength (L) – horizontal distance crest ↔ crest
    • Wave base – depth below which orbital motion ceases; approximately L2\frac{L}{2}.

Coastal-Zone Width: Contrasting Examples

  • Pacific Northwest (e.g.
    Devil’s Punch Bowl, Oregon):
    • Steep coastal mountains only a short distance inland ⇒ narrow coastal zone.
  • Gulf & Atlantic Coastal Plain (e.g.
    Cape Coral–Fort Myers, FL):
    • Very gentle topographic gradient; no close mountain ranges ⇒ broad coastal zone.
    • Tidal rivers (e.g., Caloosahatchee R.) flow through and enlarge this zone.

Factors Controlling Coastal Appearance

1 – Water-Side (Oceanic) Controls
  1. Wave & tide energy
    • Stronger, higher-energy waves ⇒ enhanced erosion.
    • Tidal range modulates daily shoreline position.
  2. Seafloor slope
    • Steep offshore profile: waves break close to the beach.
    • Gentle slope: waves break farther offshore.
  3. Coastline orientation vs. dominant wave approach
    • Headlands focus wave energy ⇒ greater erosion.
    • Embayments/bays are sheltered ⇒ sediment accumulates (deposition).
2 – Land-Side (Terrestrial) Controls
  1. Rock hardness / resistance
    • Hard, crystalline rock ⇒ cliffs & rocky shorelines.
    • Soft, unconsolidated sediment ⇒ sandy beaches.
  2. Sediment supply
    • Large river input or erodible bluffs deliver sand & mud to coasts.
  3. Tectonic setting
    • Active margins (Pacific U.S.): uplift, coastal mountain ranges, narrow zones.
    • Passive margins (Atlantic/Gulf): broad plains; many drowned river valleys (estuaries).
    • Example: Pamlico Sound, NC – a classic estuary (flooded fluvial valley).
  4. Climate
    • Humid: lush vegetation, thicker soils, stable slopes.
    • Arid: sparse vegetation, thin soils, greater slope instability (mass wasting potential).

Tides

  • Definition: Twice-daily vertical oscillation of sea level along a shoreline caused by gravitation of Moon & Sun.
  • Typical tidal range: ∼1–3 m\sim1\text{–}3\,\text{m}; local extremes exist (e.g., Bay of Fundy ≈15 m\approx15\,\text{m} or >50 ft>50\,\text{ft}).
Mechanics
  1. Gravitational bulges
    • Moon’s gravity pulls ocean water toward it ⇒ bulge on near side.
    • Centrifugal forces produce a matching bulge on the far side.
    • Earth’s rotation carries any shoreline through two bulges per 24 h24\,\text{h} ⇒ two high & two low tides daily.
  2. Sun + Moon alignment
    • Spring tide (new & full moon): Sun, Moon, Earth in line; forces reinforce ⇒ highest highs & lowest lows (largest range).
    • Neap tide (1st & 3rd quarter): forces at right angles; Moon dominates but Sun partly cancels ⇒ smallest range (lower highs, higher lows).
Ecological note
  • Inter-tidal exposures (e.g., wave-cut platforms) host tide-pool communities: sea urchins, anemones, mussels, starfish, crabs, etc.

Waves: Generation, Geometry & Energy Transport

  • Wave = surface irregularity produced primarily by wind; energy is transferred from wind → water via friction.
  • Wave sets: groups of adjacent waves of similar shape/size in open ocean.
  • Energy vs. water motion:
    • Water particles move in nearly closed vertical orbits, returning close to their starting point; energy travels horizontally.
    • Demonstrated by tsunami-propagation animations — energy crosses basins while individual water particles oscillate.
  • Wave height controls: wind speed, duration & fetch (distance wind blows over water).
    • Very strong winds → waves become steep, topple, trap air ⇒ whitecaps (foamy crests).

Near-Shore Wave Behavior

  1. Shoaling & Breakers
    • When water depth < wave base ( d<L2d<\frac{L}{2} ), lower part of wave drags on seafloor.
    • Wave slows, wavelength shortens, height increases; crest finally becomes unstable ⇒ breaks (surf).
    • Steep offshore slopes → breakers form close to beach; gentle slopes → breakers form farther out.
  2. Wave Refraction
    • Waves normally approach at an angle.
    • Segment that encounters shallow water first slows, causing wave to bend toward shoreline; concentrates energy on headlands & disperses it in bays.
  3. Rip Currents
    • Narrow, fast, seaward-flowing jets that return water piled up by breaking waves.
    • Dangerous: swimmers should stay calm, swim parallel to shore to exit, or signal for help.
  4. Sneaker Waves
    • Sporadic, disproportionately large waves that surge well beyond the normal swash zone.
    • Can knock over or sweep unsuspecting beachgoers into the ocean.
    • Notorious at Reynisfjara (near Vík), Iceland; warning signage & traffic-light alert system installed due to fatalities.

Practical & Hazard Implications

  • Engineering & planning must account for:
    • Extreme tidal ranges (harbors, tidal-power proposals).
    • Wave refraction patterns (erosion hot-spots at headlands, need for breakwaters/groynes).
    • Sneaker-wave & rip-current risk (public safety signage, lifeguard protocols).
    • Climate & sediment supply in beach-nourishment projects.

Key Numerical Relationships & Values (Useful for Exams)

  • Typical tidal range: 1–3 m1\text{–}3\,\text{m}; extreme example Bay of Fundy ∼15 m\sim15\,\text{m}.
  • Wave-base depth: dwb=L2d_{wb}=\dfrac{L}{2}.
  • Two high tides + two low tides ≈ every 24 h24\,\text{h} cycle.
  • Spring-vs-neap interval: every 14\tfrac{1}{4} lunar month (≈7 days).

Connections to Earlier Material

  • Plate-tectonic concepts (Chapter 2): Active vs. passive margins explain contrasting coastal topography.
  • Weathering/erosion principles (Chapter 6): Rock resistance directly affects shoreline morphology.
  • Fluvial processes (Chapter 8): River-delivered sediment vital for beach maintenance; drowned river valleys → estuaries.

Ethical, Environmental & Societal Considerations

  • Coastal development vs. natural dynamics: building on dunes, backshores or estuary margins can amplify storm/tide damage.
  • Habitat preservation: Inter-tidal zones host specialized ecosystems; dredging or bulkheads may disrupt them.
  • Tourism safety: Public education on rip currents & sneaker waves reduces fatalities (e.g., Iceland’s light-signal system).