Lipid Metabolism Study Notes
Digestion and Absorption of Lipids
- The Entry Point: Mouth, Stomach, and Small Intestine
- Topic: Breaking down fats for biological use.
- Goal: The primary objective is to break down massive, water-insoluble triacylglycerols (TAGs) into small, absorbable molecules.
- Process in the Mouth: Digestion in the mouth is mostly a physical process. Chewing serves to break up food, but salivary enzymes do not significantly contribute to the digestion of fats.
- Process in the Stomach:
- The churning action of the stomach transforms fat into a coarse emulsion referred to as chyme.
- Key Enzyme: Gastric Lipase initiates the chemical attack, successfully hydrolyzing approximately 10% of triacylglycerols (TAGs).
- Student-Friendly Analogy: Think of the stomach phase like trying to wash a greasy dish using only water. You might break the grease up slightly, but soap is required to finish the job. The stomach represents only the beginning of the process.
The Main Event: Emulsification in the Small Intestine
- Topic: Utilizing "Biological Soap" to dissolve fat.
- The Technical Problem: Fats and water are naturally immiscible (they do not mix). Because lipases (enzymes that digest fat) are water-soluble, they are restricted to working only on the surface of fat globules.
- The Solution - Emulsification:
- As chyme enters the small intestine, the gallbladder releases bile.
- Bile Salts: These act as biological detergents. They possess a hydrophobic (water-fearing) end that dissolves into the fat globule and a hydrophilic (water-loving) end that faces the aqueous environment.
- Key Action: This detergent action breaks a single large fat globule into thousands of microscopic droplets. This dramatically increases the surface area available for enzymatic attack.
Final Breakdown and Absorption
- Chemical Digestion:
- Key Enzyme: Pancreatic Lipases. With the massive surface area provided by emulsification, these enzymes perform the bulk of lipid digestion.
- Substrate: Triacylglycerols (TAGs) found within the emulsified droplets.
- Products: The reaction yields Monoacylglycerols and two free fatty acids.
- The Absorption Process:
- The digestion products combine with bile salts to form tiny spheres called micelles.
- Micelles: These are small enough to be absorbed by the mucosal cells lining the intestine.
- Inside the Cells: Once absorbed, TAGs are reassembled, packaged with proteins to form chylomicrons, and released into the lymphatic system for transport to the bloodstream.
Triacylglycerol Storage and Mobilization
- Adipocytes: These are specialized cells designed to store triacylglycerols (TAGs) within a large central droplet.
- Adipose Tissue: Composed of many adipocytes, this tissue is located beneath the skin and surrounding vital organs. Its primary functions include energy storage, thermal insulation, and physical protection.
- Mobilization - "Unlocking the Pantry":
- Triggers: Mobilization occurs when the body requires energy. This signal is mediated by hormones, specifically Epinephrine (the "fight or flight" hormone) and Glucagon (released during low blood sugar states).
- Pathway: These hormones activate the cAMP (cyclic Adenosine Monophosphate) pathway within the adipocyte.
- Key Enzyme: Hormone-Sensitive Lipase (HSL).
- HSL Action: HSL hydrolyzes stored TAGs, breaking them down into Glycerol and three free fatty acids.
- Release: The products are released into the bloodstream to be transported to tissues in need of energy. Fat reserves represent the body's major energy source, surpassing protein, glycogen, and glucose.
- Source: Glycerol is produced during the mobilization of triacylglycerols.
- Transport and Processing: It enters the bloodstream and is primarily processed in the liver and kidneys.
- Step-by-Step Pathway:
- Step 1: Glycerol is converted to Glycerol-3-phosphate by the enzyme glycerol kinase. This requires the conversion of ATP→ADP.
- Step 2: Glycerol-3-phosphate is converted to Dihydroxyacetone phosphate (DHAP) via glycerol-3-phosphate dehydrogenase. This requires the reduction of NAD+→NADH+H+.
- Integration: DHAP is a glycolytic intermediate; it can enter the glycolysis pathway for energy or the gluconeogenesis pathway for glucose production, effectively linking lipid and carbohydrate metabolism.
- Overall Equation:
- Glycerol+ATP+NAD+→DHAP+ADP+NADH+H+
Oxidation of Fatty Acids (β-Oxidation)
- The breakdown of fatty acids for energy consists of three major parts:
- Activation: The fatty acid must be activated by bonding to Coenzyme A (CoA).
- Transport: The activated fatty acid must be transported into the mitochondrial matrix via a shuttle mechanism.
- Oxidation: The fatty acid undergoes repetitive cycles of four reactions to produce Acetyl CoA, FADH2, and NADH.
Fatty Acid Activation and Transport
- Activation Details:
- Location: Occurs at the outer mitochondrial membrane.
- Purpose: To transform free fatty acids into a high-energy reactive intermediate.
- Reactants: Fatty acid, Coenzyme A (CoA), and ATP.
- Enzyme: Acyl-CoA synthetase.
- Product: Fatty acyl-CoA and AMP + PPi.
- Reaction: Fatty acid+CoA+ATP→Fatty acyl-CoA+AMP+PPi.
- The Mitochondrial Entry Pass (Transport):
- The Problem: Acyl-CoA molecules cannot cross the inner mitochondrial membrane, but the enzymes for oxidation are located inside the mitochondrial matrix.
- The Solution - Carnitine Shuttle:
- Step 1: The acyl group is transferred from CoA to a molecule called carnitine.
- Step 2: Carnitine carries the acyl group across the inner membrane.
- Step 3: The acyl group is transferred back to a CoA molecule inside the matrix, reforming Acyl-CoA.
The Reactions of the β-Oxidation Pathway
- Location: Mitochondrial matrix.
- Goal: To sequentially degrade fatty acyl-CoA into 2-carbon Acetyl-CoA units.
- Cycle Mechanism: A repetitive 4-step cycle targeting the β-carbon.
- Step 1: Oxidation (Dehydrogenation): Uses Acyl CoA dehydrogenase. An alkane is converted to an alkene (trans-Enoyl CoA). FAD is reduced to FADH2.
- Step 2: Hydration: Uses Enoyl CoA hydratase. Water is added across the double bond of trans-Enoyl CoA to form L-β-Hydroxyacyl CoA (a secondary alcohol).
- Step 3: Oxidation (Dehydrogenation): Uses β-Hydroxyacyl CoA dehydrogenase. The secondary alcohol is oxidized to a ketone (β-Ketoacyl CoA). NAD+ is reduced to NADH+H+.
- Step 4: Chain Cleavage (Thiolysis): Uses Thiolase. The ketone is cleaved, releasing one molecule of Acetyl-CoA and a new Acyl-CoA that is two carbons shorter than the original.
β-Oxidation Summary and Products
- For every single cycle of β-oxidation, the following are produced:
- 1 molecule of Acetyl-CoA (enters the Citric Acid Cycle).
- 1 molecule of FADH2 (1.5ATP in ETC).
- 1 molecule of NADH (2.5ATP in ETC).
- An Acyl-CoA molecule shortened by two carbons.
- Repetition: The shortened Acyl-CoA immediately re-enters the cycle. This repeats until the entire chain is converted into Acetyl-CoA.
Unsaturated Fatty Acids in β-Oxidation
- Normal double bonds in unsaturated fatty acids disrupt the standard β-oxidation flow. Extra enzymes are required to accommodate these bonds:
- Epimerase: Converts D-β-hydroxyacyl CoA into the L-β-hydroxyacyl CoA form.
- cis-trans Isomerase: Converts a cis double bond into a trans double bond.
- Purpose: These enzymes ensure the fatty acid can enter the hydration step (Step 2) of the standard pathway normally.
Energy Yield and ATP Production
- Energy Conversion Factors:
- 1NADH=2.5ATP
- 1FADH2=1.5ATP
- 1Acetyl-CoA=10ATP (via the Citric Acid Cycle)
- Example Calculation: Palmitic Acid (C16):
- Cycles: 7 cycles of β-oxidation.
- Yield: 8Acetyl-CoA, 7NADH, 7FADH2.
- Total Gross ATP: (8×10)+(7×2.5)+(7×1.5)=80+17.5+10.5=108ATP.
- Net ATP: 108−2 (for activation) =106ATP.
- Example Calculation: Stearic Acid (C18):
- Cycles: 8 cycles.
- Yield: 9Acetyl-CoA, 8NADH, 8FADH2.
- Total Gross ATP: (9×10)+(8×2.5)+(8×1.5)=90+20+12=122ATP.
- Net ATP: 122−2=120ATP.
- Comparison: Fats vs. Carbohydrates:
- Glucose (C6) yields approximately 30ATP. Three glucose molecules (18C) yield 90ATP. One Stearic acid (18C) yields 120ATP.
- Fats are approximately 33% more efficient per carbon unit.
- Energy density: Fat yields ≈9kcal/g while carbohydrates yield ≈4kcal/g, making lipids the most energy-dense storage fuel.
- Fuel Use Profiles:
- At Rest: The body burns more fat than carbohydrates.
- Low-Intensity Workout (~45% VO2 max): High percentage of calories from fat (~44%). Fat burning rate is ≈2.8cal/min.
- High-Intensity Workout (~70% VO2 max): More calories from carbohydrates, less from fat (~22%). Fat burning rate drops to ≈2.1cal/min.
- The "Fat-Burning Zone" (Low Intensity):
- Examples: Long walks, light jogging, casual cycling.
- Fuel: Fats (via β-oxidation).
- Oxygen: Breathing is controlled, ensuring a high oxygen supply for the slower but efficient oxidative pathway.
- The "Sugar Rush" (High Intensity):
- Examples: Sprinting, heavy weightlifting.
- Fuel: Carbohydrates (muscle glycogen).
- Limitation: Oxygen delivery cannot keep pace with the needs of β-oxidation; the body switches to anaerobic glycolysis for immediate ATP production.
Ketone Bodies and Ketogenesis
- Definition: Ketone bodies include Acetoacetate, β-hydroxybutyrate, and Acetone.
- Trigger: Occurs when oxaloacetate levels are low (due to high-fat/low-carb diets, diabetes, or fasting), causing the Citric Acid Cycle to slow down while Acetyl-CoA levels remain high.
- Metabolic Role:
- Acetoacetate is the central precursor.
- Reduction: Acetoacetate is reduced to β-hydroxybutyrate using NADH.
- Decarboxylation: Acetoacetate spontaneously or enzymatically produces Acetone and CO2. Acetone is often exhaled (sweet acetone odor in diabetic breath).
- Ketogenesis Steps (Liver Mitochondria):
- Condensation: 2Acetyl-CoA→Acetoacetyl-CoA.
- Second Condensation: Acetoacetyl-CoA + Acetyl-CoA + H2O→HMG-CoA.
- Chain Cleavage: HMG-CoA is cleaved into Acetyl-CoA and Acetoacetate.
- Reduction: Acetoacetate is reduced to β-hydroxybutyrate.
Utilization of Ketones (Ketolysis)
- Primary Users: Heart muscle and kidney cortex use ketone bodies for energy at any time.
- Brain Adaptation: While the brain prefers glucose and cannot use fatty acids, it can adapt during prolonged starvation to acquire up to 75% of its energy from ketone bodies. This process spares the body's glucose and prevents muscle protein breakdown.
- Conversion: Tissues absorb ketones and convert them back into Acetyl-CoA for the Citric Acid Cycle.
- Ketosis vs. Ketoacidosis:
- Nutritional Ketosis: Normal state from low-carb diets; ketone levels high but controlled, blood pH stable.
- Ketoacidosis: Dangerous state (uncontrolled Type 1 diabetes); insulin deficiency leads to runaway lipolysis. Acidic ketone bodies overwhelm blood buffers, leading to life-threatening drops in pH.
Biosynthesis of Fatty Acids: Lipogenesis
- Comparison: Lipogenesis vs. β-Oxidation:
- Location: Lipogenesis in cytosol; degradation in mitochondria.
- Enzymes: Lipogenesis uses a multienzyme complex (Fatty Acid Synthase); degradation uses separate enzymes.
- Carriers: Lipogenesis uses Acyl Carrier Protein (ACP); degradation uses CoA.
- Cofactors: Lipogenesis requires NADPH (reducing agent); degradation uses FAD and NAD+ (oxidizing agents).
- Units: Lipogenesis builds 2 carbons (via Malonyl-ACP); degradation removes 2 carbons (as Acetyl-CoA).
- The Citrate-Malate Shuttle: Because Acetyl-CoA cannot cross the mitochondrial membrane to get to the cytosol, it combines with oxaloacetate to form citrate. Citrate is transported to the cytosol and then converted back into Acetyl-CoA and oxaloacetate (requiring ATP).
- ACP Complex: Functions as a "giant CoA." Intermediates are bound to ACP. Malonyl-ACP (C3) formation is triggered by high ATP levels and requires Biotin and Mn2+.
- Unsaturated FA Biosynthesis: Desaturases remove hydrogen to create double bonds, but humans cannot form double bonds beyond C−9. Essential fatty acids like Linoleic and Linolenic must be obtained through the diet.
Cholesterol Biosynthesis and Statins
- Cholesterol: A C27 lipid essential for cell membranes and as a precursor to bile salts and hormones.
- Synthesis: Primarily in the liver from Acetyl-CoA (18 molecules required). Total endogenous synthesis is 1.5–2.0g/day.
- Phases:
- 3Acetyl-CoA→Mevalonate(C6).
- Mevalonate → Isopentenyl pyrophosphate (C5).
- Polymerization into Squalene (C30).
- Cyclization into Lanosterol, then conversion to Cholesterol (C27).
- Statins: Competitive inhibitors of HMG-CoA reductase (the rate-limiting enzyme that converts HMG-CoA to mevalonate). Examples include Atorvastatin and Simvastatin. They decrease plasma LDL and reduce the risk of atherosclerosis.