MICRO LAB FLASHCRADS

Slide 1: Ubiquity and Diversity of Microorganisms
  • Q: What does the term "ubiquity of microorganisms" mean?

    • A: It means that microorganisms are found virtually everywhere in the environment, including air, water, soil, and on everyday objects.

      PPTX


  • Q: What is the procedure for demonstrating microbial ubiquity in lab?

    • A: Swabbing various places around the laboratory and streaking the samples onto Tryptic Soy Agar (TSA) culture plates.

      PPTX


  • Q: What are the expected results of the ubiquity experiment?

    • A: Abundant bacterial and fungal growth will appear on the culture plates, showing a wide range of diverse colonies.

      PPTX


Slide 2: Aseptic Techniques
  • Q: What are the primary learning objectives of practicing aseptic technique?

    • A: To identify microbiology tools, explain and demonstrate the steps of aseptic technique, and recognize proper versus improper execution.

      PPTX


  • Q: What is the procedure used to test aseptic transfer?

    • A: 1) Transferring a pure culture to a tube of sterile media, and 2) Transferring a sterile disk into a tube of sterile media.

      PPTX


  • Q: What are the expected results for the aseptic technique test tubes?

    • A: The tube inoculated with E. coli should show growth making it turbid (cloudy), while the tube containing the sterile disk should show no growth at all.

      PPTX


Slide 3-4: Laboratory Tools & Proper Flaming
  • Q: What tools are featured in microbiology for transfers and preparation?

    • A: Inoculation needles, inoculation loops, glass spreaders, a striker, and a Bunsen burner.

      PPTX


  • Q: How do you properly flame an inoculation loop or needle?

    • A: Pass the wire starting from the base up to the loop/tip through the hottest part of the Bunsen burner flame until it glows orange-hot to incinerate any contaminants.

      PPTX


Slide 5: Bacterial Colony Morphology
  • Q: How is a bacterial colony defined?

    • A: A visible cluster of microorganisms originating from a single mother cell, representing a clone of genetically identical cells.

  • Q: What are the main physical categories used to describe colony morphology?

    • A: Form (punctiform, round, filamentous, irregular, rhizoid, spindle), Elevation (flat, raised, convex, pulvinate, umbonate), and Margin (entire, undulate, filamentous, lobate, erose, curled).

      PPTX


Slide 6: Growth Pattern in Broth
  • Q: How do you interpret microbial growth patterns in liquid broth regarding oxygen requirements?

    • A: Aerobic bacteria grow at the top where oxygen is present (forming a pellicle), whereas facultative anaerobes grow evenly throughout the tube (making it turbid).

      PPTX


  • Q: What do terms like pellicle, turbid, flocculent, and sediment mean in broth cultures?

    • A: Pellicle is a dense growth floating strictly at the top; turbid is uniform cloudiness throughout; flocculent is clumpy masses suspended in liquid; and sediment is cell accumulation settled at the very bottom.

      PPTX


Slide 7-8: The Streak Plate for Isolation
  • Q: What is the primary purpose of the streak plate method?

    • A: To progressively reduce cell concentration across quadrants so that individual, pure bacterial colonies can be isolated from a mixed culture.

      PPTX


  • Q: What is the step-by-step procedure of a streak plate?

    • A: Streak bacterial culture in a single quadrant, sterilize the loop, drag across the edge of the previous section into the next quadrant, and repeat 2 to 3 times.

      PPTX


Slide 9: The Spread Plate Method
  • Q: What is the procedure for performing a spread plate?

    • A: Place 2 to 3 drops of bacterial culture onto a TSA plate, then use a sterile glass spreader to evenly smear the culture across the entire surface of the agar.

      PPTX


  • Q: What are the expected results and use case of a spread plate?

    • A: It produces an even "lawn" of bacteria growing across the entire plate, which is heavily utilized for quantitative assays and diagnostic testing.

      PPTX


Slide 10: Using the Microscope
  • Q: What is the function of the ocular lens versus the objective lenses?

    • A: The ocular lens (eyepiece) remagnifies the image formed by the objective lenses, which are the primary lenses that initially magnify the specimen.

      PPTX


  • Q: What roles do the condenser, iris diaphragm, and focusing knobs play?

    • A: The condenser focuses light directly through the specimen, the diaphragm controls the amount of light entering the condenser, and the coarse/fine knobs adjust focus.

      PPTX


Slide 11: Simple Staining
  • Q: What is the procedure and mechanism behind a simple stain?

    • A: Staining a heat-fixed bacterial sample with a single positive basic stain (such as crystal violet) that binds electrostatically to the negatively charged cell wall.

      PPTX


  • Q: What can you determine from a simple stain?

    • A: Cell morphology (shape like bacilli or cocci), cell arrangement (clusters or chains), and approximate cell size.

      PPTX


Slide 12-14: The Gram Stain (Differential Stain)
  • Q: How does the Gram stain differentiate bacteria?

    • A: It separates bacteria based on cell wall thickness (peptidoglycan layer), using crystal violet, iodine, an alcohol decolorizer, and safranin counterstain.

      PPTX


  • Q: What are the expected results for E. coli and S. epidermidis?

    • A: E. coli is a Gram-negative bacillus that appears pink/red, while S. epidermidis is a Gram-positive coccus that appears purple.

      PPTX


Slide 15-17: Special Stains (Endospore, Capsule, Flagella)
  • Q: What structures do special stains target and what are their functions?

    • A: Endospores (highlight survival structures resistant to heat/chemicals), Capsules (protect cells from phagocytosis, visible via negative staining halos), and Flagella (protein structures used for bacterial motility).

      PPTX


Slide 18: Temperature Tolerance
  • Q: How are bacteria classified based on their temperature preferences?

    • A: Psychrophiles grow best at cold temperatures (around 4∘C), mesophiles thrive at moderate/body temperatures (around 37∘C), and thermophiles prefer high heat environments (around 55∘C or higher).

      PPTX


Slide 19: Ultraviolet Radiation Experiment
  • Q: What is the difference between bacteriostatic and bactericidal effects?

    • A: Bacteriostatic treatments temporarily inhibit bacterial growth and division, whereas bactericides permanently kill the microorganisms.

  • Q: What were the expected results of exposing covered vs. uncovered plates to UV light?

    • A: Uncovered cultures exposed to longer UV durations experience significantly more cell death (less growth) because plastic petri dish lids block UV rays.

      PPTX


Slide 20: Bacterial Metabolism (Starch)
  • Q: What enzyme is tested in the starch hydrolysis test and how is it read?

    • A: It tests for the exoenzyme amylase. Flooding the plate with iodine turns starch dark, but Bacillus subtilis secretes amylase to digest starch, leaving a clear, pale halo around the colony (E. coli leaves no halo).

      PPTX


Slide 21: Bacterial Metabolism (Catalase)
  • Q: What does a positive catalase test look like and what does it indicate?

    • A: Adding hydrogen peroxide (H2​O2​) to Staphylococcus epidermidis produces vigorous bubbles, indicating it possesses catalase to break down toxic H2​O2​ into water and oxygen gas (typical of aerobes), whereas E. faecalis does not bubble.

      PPTX


Slide 22: Bacterial Metabolism (Oxidase)
  • Q: What does the oxidase DrySlide test detect?

    • A: It tests for the enzyme cytochrome c oxidase in the electron transport chain. Pseudomonas aeruginosa turns the slide dark blue/purple within 20 seconds, confirming it is an aerobic bacterium.

      PPTX


Slide 23-25: Aerotolerance (TSA Deeps, Thioglycollate, Anaerobic Jar)
  • Q: How do obligate aerobes, facultative anaerobes, and obligate anaerobes grow in thioglycollate broth?

    • A: Obligate aerobes grow only at the top oxic zone; facultative anaerobes grow throughout the tube; and obligate anaerobes grow strictly at the bottom anoxic zone.

      PPTX


  • Q: What is the purpose of resazurin in a thioglycollate tube?

    • A: Resazurin is an oxidation-reduction indicator that turns pink/red in the presence of oxygen (oxic zone) and stays colorless in oxygen-free areas (anoxic zone).

      PPTX


  • Q: How does an anaerobic jar function?

    • A: A gas generator envelope produces H2​ and CO2​, and palladium catalyst pellets combine free oxygen with hydrogen to form water, creating an oxygen-free environment verified by a methylene blue indicator strip.

      PPTX


Slide 26: Effectiveness of Handwashing & Controls
  • Q: What is the difference between normal microflora and transient microbes?

    • A: Normal flora permanently colonize deep skin layers, whereas transient microbes are temporary environmental contaminants picked up throughout the day.

  • Q: Who was Mary Mallon and why is she discussed in this lab?

    • A: "Typhoid Mary" famously demonstrated how poor hand hygiene and asymptomatic carrier states can spread deadly pathogens like Salmonella typhi.

      PPTX


  • Q: What are the expected results of the handwashing experiment?

    • A: Unwashed and water-rinsed fingers show massive bacterial loads and diversity, whereas hand sanitizer and proper scrubbing with soap and water drastically reduce both.

      PPTX


Slide 27: Use of Adjustable Pipettors
  • Q: What are the volume ranges for standard adjustable lab pipettors?

    • A: P-10 (0.5–10μL), P-100 (10–100μL), and P-1000 (100–1000μL).

      PPTX


Slide 28-29: Quantifying Stock Concentration Using Viable Plate Count
  • Q: What is the goal of performing serial dilutions and viable plate counts?

    • A: To systematically dilute high-density stock cultures down to a countable range (30–300 colonies) so you can calculate the original concentration in CFU/mL.

      PPTX


Slide 30-31: Antibiotic Susceptibility & Disinfectants (Kirby-Bauer)
  • Q: What is a zone of inhibition and how is it interpreted?

    • A: It is the clear circular area around an antimicrobial disk where bacterial growth is prevented. Larger zones indicate high susceptibility, while little to no zone indicates resistance.

      PPTX


  • Q: Which test organism is typically most susceptible vs. most resistant across these assays?

    • A: Staphylococcus epidermidis is generally the most susceptible (easiest to kill), while Pseudomonas aeruginosa is typically the most resistant (hardest to kill) due to its outer membrane barriers.

      PPTX

      n microbiology lab handwashing experiments, instructors often use a fluorescent lotion or cream (which mimics invisible oils, transient microbes, and artificial "germs") to show how effectively students wash their hands.

      Here is what it means and why your instructor emphasizes it if the fluorescent cream doesn't all come off:

      What it Means If Fluorescent Cream is Left Behind
      • Incomplete Physical Removal: It means your handwashing technique missed certain areas, and mechanical friction or soaping wasn't thorough enough to lift the simulated oils and microbes off the skin.

      • Problem Areas (Where it usually gets stuck):

        • Underneath fingernails (the hardest spot to clean)

        • Between fingers and the web spaces

        • The back of the hands

        • Around rings, wrist creases, and cuticles

      • Real-World Application to Pathogens: In a clinical or laboratory setting, whatever areas still glow under the UV light are the exact spots where real transient microbes and pathogens would still be clinging to your skin. If you were working with a patient or a pure culture, those leftover glowing spots would represent potential cross-contamination zones or pathways for spreading infection.

      Q&A Format for Copy & Pasting
      • Q: What does the fluorescent cream in the handwashing lab represent?

        • A: It simulates invisible oils, organic matter, and transient microbial contaminants that accumulate on hands during everyday activities or lab work.

      • Q: What does it mean if fluorescent cream remains on your hands under a UV light after washing?

        • A: It indicates that your handwashing technique was incomplete, showing that soap and friction failed to mechanically remove the simulated contaminants from those specific areas.

      • Q: Which areas on the hands are most commonly missed during handwashing (where the cream stays behind)?

        • A: Underneath the fingernails, between the fingers, the backs of the hands, and around rings or wrist creases.

      • Q: What is the clinical takeaway of leaving fluorescent cream behind?

        • A: Any spot that still glows represents a place where real pathogens and transient microbes would still be alive, meaning poor hand hygiene could easily lead to cross-contamination or infection spread.