Unit 9 Chemistry I Notes

Terminology

  • Solution: A homogeneous mixture of two or more substances.
    • Solute: The substance being dissolved.
    • Solvent: The substance doing the dissolving; most common solvent is water.
  • Suspension: A solution where the particles do not dissolve and settle at the bottom (e.g., Italian dressing).
  • Colloid: A mixture where the particles do not settle but can be observed (e.g., muddy water, Jello).
  • Tyndall Effect: The scattering of light by particles in a colloid, allowing the beam to be seen.

Properties of Water

  • Water is a polar molecule with a positive and negative end, leading to the ability to dissolve other polar molecules and many ionic compounds.
  • Polar: Asymmetrical distribution of charges.
  • Nonpolar: Symmetrical distribution of charges, does not dissolve in water (e.g., gasoline, oils).
  • Miscible substances: Substances that can dissolve in one another (e.g., oil and gasoline).
  • Immiscible substances: Substances that do not mix (e.g., oil and water).

Solubility Rules

  1. Sodium, potassium, and ammonium compounds are soluble.
  2. Nitrates and chlorates are soluble; Acetates are generally soluble (except silver acetate).
  3. Chlorides, bromides, iodides are soluble (exceptions: Ag, HgI, Pb).
  4. Sulfates are soluble (exceptions: Ba, Sr, Hg, Ca, Ag, Pb).
  5. Carbonates, phosphates, and silicates are generally insoluble (exceptions: group I and ammonium).
  6. Sulfides are typically insoluble (exceptions: Ca, Sr, Na, K, NH4).
  7. Chromates are generally insoluble (exceptions: group I, ammonium, Ca, Sr).
  8. Hydroxides are insoluble (exceptions: group I, ammonium, Ba, Sr, Ca).

Electrolytes

  • Electrolytes are substances that, when dissolved, dissociate into ions and can conduct electricity (e.g., table salt).
  • Methods of dissolving:
    1. Agitate the mixture
    2. Heat the solvent
    3. Increase the surface area of the solute.

Types of Solutions

  1. Unsaturated: Contains very little solute, mostly solvent.
  2. Saturated: Contains nearly equal amounts of solute and solvent, undissolved solute settles at the bottom after stirring.
  3. Supersaturated: Contains more solute than can normally be dissolved at that temperature, visible solute may settle after substantial stirring or heating.

Effects of Temperature on Solubility

  • Generally, solubility increases with temperature for many solutes but can decrease for some (e.g. lithium carbonate).
  • Henry's Law: Increasing pressure on a gas above a liquid increases solubility of that gas in the liquid.
  • Thermal pollution can affect solubility.

Concentration of Solutions

  • Molality (m): Moles of solute per kilogram of solvent.
  • Molarity (M): Moles of solute per liter of solution.
Example Calculations
  1. Molarity of H₂SO₄:

    - M = moles/volume in L

    M = ( \frac{50.09 \text{ g}}{(98.0789 \text{ g/mol})(0.500 L)} ) = 1.02 M

  2. Molality Calculation Example:

    • Given 100g of NaCl, solubility in 500g of water:
      ( m = \frac{100g}{(58.4439 g/mol)(0.500 kg)} \approx 3.42 m \text{ NaCl})
  3. Colligative Properties:

    • Boiling Point Elevation & Freezing Point Depression depend only on the amount of solute, not its identity.
    • Change in Boiling Point: ( \Delta Tb = i \cdot Kb \cdot m )
    • Change in Freezing Point: ( \Delta Tf = i \cdot Kf \cdot m )

Van't Hoff Factor (i)

  • Ratio of actual particles in a solution to the theoretical particles based on solute mass.
  • Example: ( NaCl ) dissociates into 2 particles, so ( i = 2 ).
Example of Freezing Point Depression
  • Adding 25.00g of ( PCl_3 ) to 150g of water:
    • ( \Delta T_f = \frac{1(1.86)(25.00g)}{(137.333g)(0.1500kg)} = 2.257 ) °C; new freezing point = -2.257 °C.
Other Examples
  1. Calculate the molar mass of a solute that lowered the freezing point of benzene to 3.50°C.
    • ( \, AT_f = 1.98°C \, \Rightarrow Fwt = \frac{1.98(163.94)(0.500)}{45.0} \approx 233.72 g/mol)
  2. Find the mass of calcium hydroxide for a 650mL solution at 2.50M:
    • ( 2.50M = \frac{x(g)}{(74.092 g/mol)(0.650L)} \Rightarrow x = 120.4 g )
General Notes
  • Higher boiling points and lower freezing points occur when a solute dissolves in a pure solvent. The characteristics of solutions depend on the nature and concentration of both solute and solvent, following established colligative properties.