xray tube

  1. Cathode assembly: Negative electrode in the x-ray tube a. Contains two filaments—small and large

b. Filaments are made of tungsten (because of its  high melting point); a small amount of thorium is  added to reduce vaporization and prolong tube life

c. Filaments are heated slightly when the x-ray  machine is turned on; no electrons are ejected at  this low level of heating

d. During x-ray exposure, one filament is heated to  a level that causes electrons to be “boiled off” in  preparation for x-ray production (which is known  as thermionic emission)

e. Over time, filaments vaporize and coat the inner  surface of the x-ray tube with tungsten, leading to  tube failure

f. Cathode assembly also includes the focusing cup g. The focusing cup surrounds the filaments on three  sides

h. The focusing cup has a negative charge applied,  which tends to concentrate electrons boiling off  the filaments into a narrower stream and repel  them toward the anode

i. Electron concentration keeps the electrons aimed  at a smaller area of the anode

j. Some x-ray tubes use the focusing cup as an electronic grid that can turn the tube current on and off  rapidly, allowing for very short and precise exposure  times, such as times needed for rapid serial expo sures (referred to as a grid-controlled tube)

  1. Anode: Positive electrode in the x-ray tube

a. Consists of a metal target made of a tungsten– rhenium alloy (because of its high melting point and  high atomic number) embedded in a disk (or base)  of molybdenum with a motor to rotate the target

b. Must be able to tolerate extremely high levels of  heat produced during x-ray production


  1. Glass envelope with window

a. The cathode and target are inside the glass envelope; some models use a partial metal envelope

b. Glass envelope also contains a vacuum so that electrons from the filament do not collide with atoms

c. Tube window: thinner section of glass envelope that  allows x-rays to escape

  1. Tube housing: Encase the x-ray tube

a. Made of aluminum with lead lining

b. Supports and protects the tube, restricts leakage radiation during exposure, and provides electrical  insulation

c. Anode rotates from 3300 to 10,000 rpm, depending on tube design

d. Rotation is achieved using of an induction motor  located outside the x-ray tube, which turns a rotor  located inside the x-ray tube; the target is attached  at the end of the rotor

e. Rotation of the target allows for greater heat  dissipation

f. Rotation of the target is stopped by a braking  action provided by the induction motor

g. The x-ray machine should never be shut off immediately after an exposure; the machine should not  be shut off until the target has stopped rotating

h. Without the braking action, the target may spin  for 30 minutes, causing great strain on the bearings i. Electrons strike the target on the focal track (some times called the focal spot)

j. The focal track is beveled, producing the target  angle

k. The target angle allows for a larger actual focal  spot (area bombarded by electrons) and also produces a smaller effective focal spot (the area seen by the IR)

l. The larger the actual focal spot, the greater the heat  capacity; the smaller the effective focal spot, the  greater the radiographic image sharpness

m.This effect is called the line-focus principle 

n. Target angle may be 7 to 20 degrees, depending on  tube design

o. Exposure switch should be activated in one continuous motion, activating the rotor and then the  exposure button

p. The equipment allows the rotor to come up to  speed before making the exposure

q. The radiographer does not control this by acti vating the rotor and waiting to press the exposure  button

r. Activating the rotor and allowing it to operate by  itself results only in unnecessary heating of the filament and wear on the induction motor, shortening tube life

c. Also contains an oil in which the x-ray tube is  immersed to assist with cooling and additional electrical insulation