Chapter Two Section (14) Transistor Output: Transistor Control in Welding Power Sources

Transistor Operation in Welding Power Supplies

  • Transistors are placed on the output side of the power supply operating in switch mode.
  • Rapid switching between full load and zero value minimizes power loss from resistive heating and optimizes energy efficiency.
  • Output power is controlled by adjusting the ratio of on-time (switch closed) to off-time (switch open).

Output Control Systems

  • Frequency Modulation: Employs a fixed pulse width while varying the frequency to control average on-time.
  • Pulse Width Modulation: Holds the pulsing frequency fixed while varying the relative amount of on-time to off-time.

Switching Frequency Specifications

  • Switching operates at a substantially higher rate than the 60 hertz60\,\text{hertz} line frequency to minimize arc disruption and maximize control response speed.
  • Typical switching frequencies range from 1,0001{,}000 to over 10,000 perks10{,}000\,\text{perks}.
  • Switch regulator designs serve as the forerunners to modern welding power sources.

Advantages and Disadvantages

  • Advantages:
    • Changes to the output occur at the switching frequency, making response faster than SVR.
    • Remote control capabilities and feedback integration are supported.
    • Switch settings can be preprogrammed for various pulse times.
  • Disadvantages:
    • Audible sounds generated at switching frequencies within the audible range can be annoying.