glassware techniques and measurement

  • general glasswear ( beakers, ect) are only an appx. meausre and cannot be used where precisiona nd accuracy are a concern

  • Volumetric lab glassware ( pipets, burets, and volumetric flasks ) , are used to meausre volumes

    • important to read value corrected

    • Meniscus =curvature of liquids in glass containers

    • your eye must be level with the top of the liquid and must record the volume at the bottom of the meniscus

  • graduated cylinders

    • hight of a column of liquid

    • small diameter = more accurate

  • pipets and burets

    • calibrated “ To deliver “( TD )

      • a very precisely. known amount of liquid at a given temperature

      • marked with the a mount, precision with which they can deliver it, and temperature at which it was calibrated

  • Volumetric grass with a single mark is designed to measure one specific volume of liquid with high precision

  • Density = Mass/Volume

  • water ~ 1.0 g/mL

    • object with density less than water will float

    • greater will sink

  • generally density of a

    • solid = g/cm³

    • liquid = g/mL

    • gas = g/L

  • mass of a object can be determined by difference

  • percent error

    • uncertainty

    • compare calculated desnity with known desnity by calculating percent error

    • Percent error =( |Experimental Value - Accepted Value | / ( Accepted Value ) ) X 100%


  •  percent error is always positive

  • Procedure

    • 100mL beaker and put 60 mL of unknown solution into oi t

    • weigh a clean and dry 10mL graduated cylinder on a analytical balance

    • record the mass using the appropriate number of sig figs and units

    • pour 10 mL of solution into the 10 mL graduated cylinder and weigh it on the same balance

    • Record the mass using appropriate units and number of sig figures . Make sure to look at the volume reading and record your observation

    • empty and dry cylinder and repeat process 4 more times to get 5 trials

  • part 2 denisty fo water

    • prepare and fill buret with deionized water

    • lok at lines on buret

    • note that the markingon the buret start with 0.00 mL on the top

    • read teh volume to one-hundreth of a milliliter which is two places past the decimal

      • ex: 1.01 mL

    • record the mass of an empty 100 mL beaker

    • dispense a small volume of DI water into your preweighed beaker

    • you may choose any volume to dispense between 3 and 5 mL

    • read teh mass of the beaker.+ water on a analytical balance

    • record the mass using sig figs and units

    • record the final volume in the buret , to two decimal places

    • empty beaker and dry it for the next trial

    • add a new sample of water ( 3 - 5 mL ) into beaker and record the volume dispensed

    • measure the mass of the beaker and water nad record it in the datat table

    • dispense three more samples of water as describes for a totla of fiv e separate volume and mass measurements

    • pour about 50 mL of DI water into the beaker, measure and record teh temperature of teh water

  • Calculations

    • calculate the density of unknown liquid for each trial

    • determien average density of unknown liquid

    • determine percent error between average value and accepted value for density fo unknown liquid

    • Calcualte density fo wate rfor each trial

    • determine average density fo water

    • determien percent error ebtween average value and the accepted value for the density of water at the expieremntla temrpatuer