Comprehensive Physics Study Guide: Objective Exam Collections (2019-2024)
General Examination Context: Physics Part-II Objective Papers (2015–2024)
Paper Type: Physics Paper II (Objective Type), Inter (Part-II) for Sessions including 2015–2017 through 2022–2024.
Total Marks:17
Time Allowed:20Minutes
Format: Multiple-choice questions (MCQs) with four options (A, B, C, D).
Guidelines: Use a marker or pen to fill the circles; cutting or multiple fills result in zero marks for that specific question.
Electrostatics: Principles and Applications
Charge Calculation (Millikan Experiment): The charge q on a droplet in Millikan's experiment is calculated using the formula:
q=Vmgd
Electrostatic Applications: Common technological applications of electrostatics include the Photocopier and Inkjet Printers.
Electric Flux (Φ):
The SI unit of electric flux is Nm2C−1.
Electric flux does not depend on the specific shape of the closed surface; it depends on the charge enclosed and the medium.
Electric Intensity (E):
Close to an infinite sheet of charge: E=2ϵ0σ.
Between two oppositely charged parallel plates: E=ϵ0σ.
The negative of the potential gradient is defined as the electric field intensity (E=−ΔrΔV).
Coulomb's Law and Interactions:
If the distance between two point charges is halved, the electric intensity becomes 4 times stronger (E∝r21).
Force between point charges (10μC and 40μC) being 9000N results in a distance calculation based on F=r2kq1q2.
In the presence of air, if the force is 80N and a dielectric like Germanium (ϵr=16) is introduced, the force reduces to 5N (F′=ϵrF).
Capacitors and Dielectrics:
The relative permittivity (ϵr) for air is approximately 1.0006.
Removing a dielectric from a charged capacitor increases its energy (if isolated), whereas introducing a dielectric between the plates decreases the energy stored (U=2CQ2 where C increases).
Kinetic Energy and Potential: A particle with a charge of 2e falling through a potential difference of 3.0V gains energy equal to 6.0eV.
Current Electricity and Circuit Laws
Resistance and Resistors:
Current passing through three resistances (10Ω, 20Ω, and 30Ω) connected in series to a 9V battery is 0.15A (Note: specific paper choices may vary based on given totals).
If a wire of 9Ω is cut into three equal parts (3Ω each) and connected in parallel, the equivalent resistance is 1Ω.
The heat produced by current passage is governed by Joule's Law: H=I2Rt.
A substance with a negative temperature coefficient of resistance is Carbon.
Units and Constants:
1Ohm×1Farad is equivalent to 1Second.
1Coulombpersecond is defined as 1Ampere.
Kirchhoff’s Rules: Kirchhoff's second rule (Loop Rule) is a statement of the Law of Conservation of Energy.
Circuit Components:
A Potentiometer is used to determine the internal resistance of a cell.
A Voltmeter is always connected in parallel with a circuit component.
An Ammeter is always connected in series.
Electromagnetism and Magnetic Fields
Magnetic Forces on Conductors:
Two parallel straight wires carrying current in the same direction will attract each other.
Work done by a magnetic force on a charge particle moving through a magnetic field is always zero (force is perpendicular to velocity).
Magnetic Intensity and Units:
The SI unit of magnetic induction is the Tesla (T).
1Tesla=1NA−1m−1.
The relationship between Tesla and Gauss (G) is 1T=104G.
Devices and Motion:
In a Cathode Ray Oscilloscope (CRO), the grid controls the number of electrons (and thus the brightness).
The sweep voltage in a CRO is provided to the x-plates.
Lorentz Force: The force acting on a particle in both electric and magnetic fields is F=Fe+Fm.
Torque (τ) on a current-carrying coil: τ=NIABcos(α) where α is the angle between the magnetic field and the plane of the coil. Torque is minimum when the angle between the plane of the coil and the magnetic field is 90∘.
Atomic Magnetism: The source of magnetism in an atom is the orbital and spin motion of electrons.
Galvanometer: The relationship between current (I) and deflection angle (θ) is I∝θ. The restoring couple is provided by the twist in the suspension wire.
Electromagnetic Induction and Alternating Current (A.C.)
Inductance:
Inductance is measured in Henry (H).
The energy stored in an inductor is in its magnetic field: U=21LI2.
Induced emf in a 1mH inductor where current changes from 5A to 3A in 1ms is 2V.
Inductance of a coil is proportional to the square of the number of turns (L∝N2).
A.C. Generators and Circuits:
If the angular frequency (ω) is doubled, the time period (T=ω2π) becomes half.
Motional emf formula: ϵ=vBLsin(θ). For L=1m, v, B, and θ=30∘, the emf is 0.5vB.
Root Mean Square (r.m.s.) value: For a peak voltage V0=100V, the Vrms≈70V (V0/2). For a peak current of 20A, Irms=14.1A.
The sum of positive and negative peak values is the peak-to-peak (p−p) value.
An ordinary D.C. ammeter measures the average value of A.C. over a cycle, which is zero.
Resonance and Phase:
Resonance condition in RLC series circuits: XL=XC.
In a pure resistor A.C. circuit, voltage and current are in phase.
In a parallel resonance circuit at resonance, impedance is maximum.
Power factor is 1 for a pure resistor.
Transformers: If a battery (D.C.) is connected to the primary of a transformer, the secondary voltage will be zero because there is no change in flux.
Electronics and Solid State Physics
Materials:
Example of a ductile material: Lead.
Example of a brittle substance: Glass.
Non-crystalline solid: Nylon.
Operational Amplifiers (Op-Amps):
The input resistance between (+) and (-) inputs is very high (order of Mega Ohms).
Transistors:
Three regions: Emitter, Base, and Collector. The central region is the Base.
The size of the base is of the order of 10−6m.
In a common emitter amplifier, the input and output signals are 180∘ out of phase.
Current gain (\beta) calculation: If IB=1mA and IE=100mA, then IC=99mA and current gain is approximately 99.
Semiconductors and Diodes:
Potential barrier of Silicon at room temperature is 0.7V.
A semiconductor behaves as an insulator at 0K.
Donor impurities: Antimony, Phosphorus, Arsenic (Aluminium is an acceptor).
Full-wave bridge rectifiers require 4 diodes.
Modern Physics and Relativity
Special Relativity:
In the time dilation expression, the quantity 1−c2v2 is always less than one.
Mass-energy equivalence: 1kg of mass is equivalent to 9×1016Joules.
Relativistic length reduction to half occurs at a specific velocity involving a factor of c.
Quantum Phenomenon:
Matter waves idea was given by de-Broglie.
Momentum of a photon: p=λh=chf.
Energy of a Radio Wave photon is of the order of 10−10eV.
Stopping potential increases with the frequency of radiation.
Photon-Matter Interaction:
X-rays eject electrons via the Photoelectric Effect.
In Annihilation of Matter, photons move in opposite directions to conserve momentum.
Low energy photon: Infrared light.
Atomic and Nuclear Physics
Atomic Models:
Ionization energy: The energy required to remove an electron from the first Bohr orbit (13.6eV for Hydrogen).
Inner shell transitions produce Characteristic X-rays (Kα occurs from L to K shell).
Spectral series: Balmer series lies in the visible region; Paschen series starts from n=3.
Nuclear Decay and Fission:
Alpha (α) decay decreases the charge number by 2.
Beta decay (β): Thorium transforming to Protactinium involves emitting a beta particle.
Slow neutrons cause fission in Uranium-235.
Half-life of Uranium-239 is approximately 23.5minutes.
Nuclear Reactors and Safety:
Cadmium rods are used to absorb neutrons and control the chain reaction.
In Karachi Nuclear Power Plant (KANUP), Heavy Water is used as a moderator.
Absorbed Dose is defined as Energy absorbed per unit mass (D=ME).
Radio Therapy for cancer utilizes Cobalt-60 or Iodine-131.
Subatomic Particles:
Leptons do not experience the Strong Nuclear Force.
Mesons are made of a pair of a quark and an anti-quark.
Wait time/Dead time of a G.M. counter is approximately 10−4s.
The temperature of the core of the sun is about 20million∘C (20M∘C).