Limits and One-Sided Limits Study Guide
Introduction to Limits and Numerical Analysis
The study of limits focuses on understanding how a function behaves as its input variable gets arbitrarily close to a target value.
To analyze the function near , consider inputs approaching from both below () and above ():
As gets closer to , the corresponding output values get arbitrarily close to .
Expressed in standard mathematical notation:

Informal Definition and Core Concepts of Limits
Let be a function defined near a real number , except possibly at itself.
The formal limit notation is:
This equation is read as "the limit of as approaches equals ".
It signifies that the values of get arbitrarily close to whenever is sufficiently close to .
Fundamental Principle: A limit describes the behavior of a function near , not necessarily its behavior at .
The limit expression and the function evaluation represent entirely different mathematical objects.
Intuitive Conceptualization: The Road Metaphor
To visualize a limit geometrically, imagine driving along the graph as if it were a road, where horizontal motion represents changing -values and vertical motion represents -values.
As the driving position's -coordinate approaches , answer two diagnostic questions:
Is the vertical height approaching a single specific number?
Are the numbers approached from the left side and the right side equal to each other?
If the answer to both questions is "yes", then the limit exists and equals that common height value.
Basic Examples and Functional Behavior Near Points
Consider the absolute value function defined piecewise as:
As from either the negative or positive direction, approaches :
In this scenario, the limit value is identical to the function value at that point:

When a Limit Does Not Exist
A limit fails to exist when a function exhibits conflicting behavior from opposite directions near the point of interest.
Consider the piecewise function:
Examining the behavior near :
Approaching from the left (), approaches .
Approaching from the right (), approaches .
Because the leftward and rightward behaviors do not target the same value, Does Not Exist (DNE).

Relationship Between Limits and Function Values
Existence Without Function Definition: A limit can exist even if the function is undefined at .
For example, consider:
At , is undefined because division by zero is mathematically invalid.
However, as approaches from either side, the values of approach :
Key Point: The defined value is not required to exist for to exist.

Limit Differing From Function Value: A limit can exist and be well-defined while being completely different from .
Consider the function:
The nearby behavior follows the continuous curve , which approaches as :
However, the defined function value at is explicitly specified as:
Consequently, .

One-Sided Limits: Definitions and Notation
Left-Hand Limit:
Written as:
Defined as the value that approaches as approaches strictly using values strictly less than ().
Notation denotes approach from the left (negative direction relative to ).
Right-Hand Limit:
Written as:
Defined as the value that approaches as approaches strictly using values strictly greater than ().
Notation denotes approach from the right (positive direction relative to ).
The One-Sided Limit Criterion for Two-Sided Limits
Criterion: The standard two-sided limit exists if and only if both one-sided limits exist and are equal to the same finite value :
Revisiting Absolute Value :
Left-hand limit:
Right-hand limit:
Since , the two-sided limit exists and \lim_{x \to 0} |x| = 0$.\n\n- **Revisiting Jump Discontinuity Function:**\n - For f(x) = \begin{cases} x - 1, & x \geq 0 \ x + 1, & x < 0 \end{cases}:\n - Left-hand limit: \lim_{x \to 0^-} f(x) = 1\n - Right-hand limit: \lim_{x \to 0^+} f(x) = -1\n - Since 1 eq -1\lim_{x \to 0} f(x) is DNE.\n\n\n\n# Comprehensive Piecewise Example Analysis\n\n- Consider the piecewise-defined function:\n\nf(x) = \begin{cases} 2\sin(x), & 0 \leq x < \pi \ \frac{x}{\pi} + 1, & \pi \leq x < 3\pi \end{cases}\n\n- **Evaluation of f(\pi):**\n - Look for the domain condition that includes x = \pi\pi \leq x < 3\pi.\n - Evaluate using the formula for that branch: f(\pi) = \frac{\pi}{\pi} + 1 = 1 + 1 = 2\n - On the graph, this corresponds to the solid closed circle located at (\pi, 2).\n\n- **Evaluation of \lim_{x \to \pi^-} f(x):**\n - Approaching \pix < \pif(x) = 2\sin(x).\n - Calculate: \lim_{x \to \pi^-} 2\sin(x) = 2\sin(\pi) = 2 \times 0 = 0\n\n- **Evaluation of \lim_{x \to \pi^+} f(x):**\n - Approaching \pix > \pif(x) = \frac{x}{\pi} + 1$.
Calculate:
Evaluation of :
Compare the two one-sided limits at :
Because , the left-hand and right-hand limits are unequal.
Conclusion: Does Not Exist (DNE).
Evaluation at Boundary :
Evaluation of : The domain strictly excludes , so is undefined unless explicitly specified otherwise.
Left-hand limit at :
Right-hand limit at : cannot be evaluated without additional function definitions for .